The equipment only charges when it is switched off. During
charging the charge indicator lights up.
• Only recharge when performance of the machine noticeably
drops.
• When the battery is fully charged the equipment can be used
approx. 60 minutes.
Cutting with attachment combs
The equipment can be used with or without attachment combs
depending on the hair cut you want.
The attachment combs give the following cutting lengths:
Setting Hair length in mm
1 4 24
2 6 26
3 7 27
4 9 29
5 10 30
6 12 32
7 13 33
8 15 35
9 16 36
10 18 38
11 19 39
12 21 41
13 22 42
Fixing attachment comb
• Press the attachment control button (D) to position "1" for
snap on or off attachment comb.
• Grasp the required attachment comb by the side guide brackets
(Fig 3a) and carefully place it in the notch in the equipment
until it snaps into place (Fig 4).
• Set the required hair length by pressing the button (D) to
adjust the attachment comb up & down.
• Adjustment is carried out at the side of the equipment by
pressing the cutting length control button.
• The attachment comb will be locked automatically when the
equipment is switch on.
Removing attachment comb
• Move the control Button (D) to position"1"
• Grasp the attachment comb by the two side guide brackets and
pull it out of the equipment (Fig. 3b). And push button D at
the same time.
Stainless Steel Blade
This hair clipper comes with a stainless steel blade. The blade
is already oiled. The oil may have run out of the blade during
transport. We therefore advise you to apply a drop of oil before
using the hair clipper. We also recommend you to add a drop of
oil to the hair clipper before each use. If the blade feels hot or
does not run smoothly, a drop of oil should be applied to the
blade.
Remark:
Provided oil is only for preservation of the cutting blade if the
hair clipper is not in use for a month. Then add a drop.
Tips for a successful styling.
• Make sure you choose the correct attachment comb and
setting.
• Make sure that the equipment is clean and the battery is
charged.
• Hold the equipment in such a way that the flat side of the
attachment comb is pointing towards the head and guide it
slowly but steadily through the hair (Fig 8).
• As a general rule, start at the sides or on the neck and cut
towards the middle of the head (Fig 9). Then cut the hair on
the forehead towards the middle.
• Cut hair more than 40 mm long with a hairstyling comb
(Fig.10).or hold it between your fingers (Fig.11).
• Stop cutting from time to time, comb the hair out and check
the result so far.
• Regularly shake and blow hair out of the equipment. If you
have collected a lot of hair in the attachment comb, take it out
clean it and blow it clear.
• Clean the equipment after each use (Fig. 5/6).
