792903

Carina Power and Stretch II Manual

43
Zoom out
Zoom in
Previous page
1/116
Next page
42
Attention:
hen inserting or removing the
bobbin, the needle must be fully
raised.
T
1
2 by the hinged
latch
3. Remove the bobbin of the bobbin
case.
5
6
7. Make sure the bobbin case finger
(b) fits into the notch (c) at the top
of the race as shown.
If the bobbin case is not properly
placed back into the machine, it will
fall out of the shuttle immediately after
starting to sew.
urn power switch to off ("O") before
inserting or removing the bobbin.
. Remove the sewing table, then
open the hinged cover.
. Pull the bobbin case
(a).
4. Hold the bobbin case with one
hand. Insert the bobbin so that the
thread runs in a clockwise direction
(arrow).
. Pull the thread through the slit and
under the finger. Leave a 6 inch tail
of thread.
. Hold the bobbin case by the hinged
latch.
W
Note:
Attention:
lacer l'aiguille dans sa position la
plus haute et insérer ou retirer
ensuite la canette.
ttention:
M
S
ettre toujours le commutateur
principal sur "O" avant de retirer ou
placer la canette.
1. Ouvrez le couvercle à charnière du
bras libre.
2. Tenir la canette par le petit clapet
(a) et l'enlever.
3. Enlever la bobine de la canette.
4. Tenez le boîtier à canette d'une
main. Introduisez la canette de
façon à que le fil s'enroule dans le
sens des aiguilles d'une montre
(flèche).
5. Tirer le fil par la fente et en dessous
du ressort. Laisser pendre 15 cm
de fil.
6. Maintenez le loquet du boîtier à
canette entre le pouce et l'index.
7. Faire attention à ce que la canette
soit bien positionnée dans
l'encoche.
i la canette n'est pas positionnée
correctement, elle tombera de la
machine dès que vous commencez à
coudre.
P
A
Pozor:
Při vkládání a vyjímání cívky musí
být jehla v nejvyšší poloze.
Pozor:
P cívky
nastavte hlavní vypínač na O".
1. Otevřete spodní kryt.
2. Přidržte cívkové pouzdro na krytu
(a).
3. Vyjměte cívku z cívkového
pouzdra.
4. Jednou rukou podržte cívkové
pouzdro. Cívku vložte tak, aby byla
nit navinutá ve směru hodinových
ručiček (šipka).
5. Nit protáhněte do drážky a pod
pružinu. Nechejte nit v délce 15 cm
vyvěsit.
6. Přidržte cívkové pouzdro na krytu.
7. Dbejte na to, aby se ramínko
cívkového pouzdra (b) usadilo do
zářezu dráhy chapače (c).
Pokud by cívkové pouzdro nebylo
bezvadně umístěné ve stroji, vypadlo
by z tělesa, jakmile začnete šít.
řed vložením nebo vyjmutí
"
Vložení cívky
Mise en place de la canette
Inserting bobbin
FR
CZ
EN
… 43 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Carina Power and Stretch II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Carina Power and Stretch II in the language / languages: English, German, French as an attachment in your email.

The manual is 1.12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info