737734
94
Zoom out
Zoom in
Previous page
1/138
Next page
Maintenance
Technical and visual modifications as well as misprints reserved - © 2019 by ERGO-FIT GmbH & Co. KG
Then pull the strap out of the bracket and open the cuff as shown in Fig.3
Fig. 3: Sketch of a cuff cover
On the lower right side, the Velcro can be opened up to the tube inlet. Then the cuff bladder
can be pulled out to the right, and the clamping yoke can be pulled down from the cuff
cover.
Follow the reverse procedure to install a new cuff cover:
First put on the cuff cover as shown in Fig. 3, and then thread the clamping yoke from the
right to the far left. Then open the Velcro fastener on the lower right side completely and
thread the cuff bladder back into the cover in such a way that the microphone in the bladder
is positioned at the level of the marking. The bladder closes flush with the „Index“ marking on
the left side. The bladder should be flush, it must not be bent over, twisted or overlapping. If
the bladder fits properly, the Velcro fastener can be closed. Finally, the „adjustable cone“
strap is threaded through the clamping yoke and closed with the Velcro.
As described, a cuff cover can also be removed, washed and re-attached to the bladder.
Cleaning the SPO
2
Clips:
Before cleaning the SPO2 module disconnect the connectors at the control panel.
Clean the sensor with a soft, damp cloth and a mild detergent. The manufacturer
recommends Klenzyme by Steris Corporation.
Do not use aggressive disinfectants. Sensors can be damaged. The manufacturer
recommends isopropanol (70%) or high level disinfection with CIDEX OPA by
Johnson and Johnson Corporation.
88
94


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cardiowise XRCISE Line at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cardiowise XRCISE Line in the language / languages: English as an attachment in your email.

The manual is 5,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cardiowise XRCISE Line

Cardiowise XRCISE Line User Manual - German - 148 pages

Cardiowise XRCISE Line User Manual - French - 144 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info