737736
13
Zoom out
Zoom in
Previous page
1/56
Next page
Technical and optical modifications as well as misprints reserved - © 2017 by ERGO-FIT GmbH & Co. KG
7
XRICSE CARE - Description
3.5.4 Individual or group training
A patient can either be entered in a slot for individual training or train within a group.
Group training makes sense if the same group of patients always shows up for a training
session. These patients are put into a group in the XRCISE CARE software. At the start of
training, the patients in the group can be assigned to the slots with a few simple mouse clicks.
This saves time. The training itself can either be started for all patients at the same time, or
individually per patient. As in the individual training, each patient in the group can go through
their individual training.
3.5.5 Training on equipment
Training on an ergometer or treadmill is categorically divided into 5-phase training. It is
divided into:
AP1 : Warm-up phase 1
AP2 : Warm-up phase 2
TP : Training phase
EP1 : Recovery phase 1
EP2 : Recovery phase 2
A constant load is applied in the phases AP1 and EP2, while the load is slowly increased or
decreased in the phases AP2 and EP1. The load can also vary during the actual training
phase.
The therapist enters the training parameter settings and adjusts them individually to each
patient.
3.5.6 Pulse, load, and interval training as well as Intelli mode
A 5-phase training on equipment is performed under either load or pulse control.
A pulse-controlled training can only be performed with an ergometer training, not with a
treadmill training. During a pulse controlled training, the heart rate signal of the applied ECG
sensor is included in the ergometer load control. The therapist specifies a patient-dependent
target heart rate. The XRCISE CARE software compares the current value from the ECG
sensor with the specified target value and modifies the ergometer control signal
correspondingly. This causes the ergometer to adjust the load to the patient.
During load controlled training, the therapist specifies the patient-dependent maximum load
for the exercise equipment. During the 5-phase training, the exercise equipment increases
the load up to the specified target value according to the specified training profile.
Interval training is always load controlled and can only be selected for ergometer training.
During interval training, very short load phases alternate with short recovery phases. The
advantage of interval training is the low stress on the cardiovascular system with simultaneous
training of the musculature.
If the Intelli mode is activated during load controlled training, the load in the AP1 and EP2
phases is at a specific ratio relative to the load during the training phase. This ratio is defined
in the configuration menu
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cardiowise XRCISE Care at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cardiowise XRCISE Care in the language / languages: English as an attachment in your email.

The manual is 3,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cardiowise XRCISE Care

Cardiowise XRCISE Care User Manual - German - 58 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info