562788
16
Zoom out
Zoom in
Previous page
1/28
Next page
Bedienelemente des Subwoofers
Netzschalter: Zur Inbetriebnahme des Subwoofers
stellen Sie den Schalter in Position „ON“. Um die
Stromversorgung zu unterbrechen schalten Sie den
Subwoofer am Netzschalter aus (Abb. 8).
Betriebsanzeige: Die LED leuchtet rot, wenn sich Ihr
Subwoofer im Standby Modus befindet. Ist der
Subwoofer in Betrieb leuchtet die LED grün.
Amplifier Mode: Ist beim Netzschalter die Position
„ON“ gewählt kann mit dem Amplifier Mode
Schalter (Abb. 9) zwischen zwei Betriebsarten
gewählt werden. In der Stellung „AUTO“ schaltet
sich der Subwoofer bei anliegendem Musiksignal
automatisch ein. Bei ausbleibendem Musiksignal
geht Ihr Subwoofer automatisch (nach ca. 3- 10
Min.) wieder in den Standby Modus. Steht der
Amplifier Mode Schalter auf „ON“ bleibt der
Subwoofer immer zwangseingeschaltet.
Um die Endstufe Ihres Subwoofers vor einer
möglichen Überlastung zu schützen, wurde sie
mit einer Netzsicherung (Abb. 10) ausgestattet.
Bitte achten Sie bei einem Wechsel der Sicherung
unbedingt darauf, dass die Endstufe spannungs-
frei und der Netzstecker gezogen ist. Außerdem
ist darauf zu achten, dass nur Sicherungen
verwendet werden, die den vorgegebenen
Werten entsprechen (0,8 A = 230 Volt,
1,6 A = 120 Volt).
9
Subwoofer operating controls
Power switch: To switch on the subwoofer, flick the
switch to the “ON” position. To cut the power,
switch the subwoofer off using the power switch
(fig. 8).
Display: LED is red when your subwoofer is in
Standby Mode. When the subwoofer is in use the
LED is green.
Amplifier Mode: When the power switch is set to
“ON”, the Amplifier Mode switch (fig. 9) can be
used to select from two operating modes. In the
“AUTO” position, the subwoofer automatically
switches itself on when a musical signal is
detected. In the absence of any musical signal
your subwoofer automatically (approx. after 3-
10 mins.) returns to Standby Mode. If the
Amplifier Mode switch is “ON”, the subwoofer
will automatically stay switched on.
In order to protect the main amp of your
subwoofer against a possible overloading it was
equipped with a fuse (fig. 10). Please make sure
when changing the fuse that the power of the
main amp is disconnected. In addition it is to be
made certain that only fuses are used which
correspond to the given values
(0.8 A = 230 volts, 1.6 A = 120 volts).
8
10
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Canton Movie CD 102 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Canton Movie CD 102 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 0,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info