562750
41
Zoom out
Zoom in
Previous page
1/48
Next page
41
Problem Possible cause Solution
DM System hums. 1. Signal lines from source device to DM System
too long.
1. Use shorter signal line.
2. Signal line used is not fault-protected or the
protection has been damaged (defective).
2. Change signal line for a fault-protected line.
3. Ground loop (ripple pickup) generated. 3. A ground loop can be generated when two or more
devices connected via a signal line (cinch) are plugged
into separate sockets (e. g. amplifier and computer). Plug
all devices connected to the DM System into a multiple
socket output using safety plugs.
4. Another piece of equipment on the same
circuit has no interference suppression
(e.g. fridge).
4. Switch off possible sources of interference to test; unplug
the device concerned to see if the humming noise disap-
pears or connect the source of interference to a different
circuit (L1, L2 or L3). (Where necessary take advice from
your electrician.) Insert a special “ferrite common mode
filter” (available from specialist retailers) between the
amplifier and the DM System to eliminate the humming.
Turn the power plug round to reduce the so-called ripple
voltage (particularly important if the source device is not
earthed).
English
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Canton DM50SE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Canton DM50SE in the language / languages: English, German as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info