615742

Canon XF200 Manual

223
Zoom out
Zoom in
Previous page
1/246
Next page
223
Troubleshooting
Video noise appears on screen.
- Keep a distance between the camcorder and devices that emit strong electromagnetic fields such as near powerful
magnets and motors, MRI machines or high-voltage power lines.
Horizontal bands appear on the screen.
- This is a phenomenon typical of CMOS image sensors when recording under some types of fluorescent, mercury or
sodium lamps. This is not a malfunction. You may be able to reduce the symptoms by setting [Camera Setup] >
[Flicker Reduction] to [Automatic] and/or by setting [Camera Setup] > [Shutter] > [Manual] to [Speed] and the
shutter speed to a value matching the frequency of the local electrical system (1/50* or 1/100 for 50 Hz systems, 1/60
or 1/120 for 60 Hz systems).
* May not be available depending on the frame rate.
Audio cannot be recorded.
- The AUDIO IN selection switch is not set correctly (A 101).
- An external microphone connected to the INPUT 1/INPUT 2 terminal requires phantom power. Set the corresponding
INPUT 1/INPUT 2 audio input selection switch to MIC+48V (A 101).
- The external microphone connected to the MIC terminal is not turned on or its battery is empty.
Audio is recorded at an extremely low level.
- The audio level for CH1 or CH2 is set to M, and the recording level is set too low. During 4-channel audio recording:
[Audio Setup] > [Audio Input] > [CH3/CH4 Mode] is set to [Manual] and [CH3/CH4 Level] is set to a level too low.
Check the audio level meter on the screen and adjust the audio level correctly (A 103, 104).
- The microphone attenuator is on. Turn off the microphone attenuator (A 100, 102).
Sound is distorted or is recorded at lower levels.
- When recording near loud sounds (such as fireworks, shows or concerts), sound may become distorted or it may not
be recorded at the actual levels. Activate the microphone attenuator (A 100, 102), or adjust the audio recording level
manually.
The picture is displayed correctly but there is no sound from the built-in speaker.
- Speaker volume is turned off. Adjust the volume (A 147).
- If headphones are connected to the camcorder, disconnect them.
Recording Media and Accessories
Cannot insert the recording media.
- The CF card or SD card you are trying to insert is not facing the correct direction. Turn it over and insert it.
Cannot record on the CF card.
- A compatible CF card must be used (A 38).
- Initialize the CF card (A 41) when you use it with the camcorder for the first time.
- The CF card is full or it already contains the maximum number of clips (999 clips). Delete some clips (A 152) to free
some space or replace the CF card.
Cannot record on the SD card.
- A compatible SD card must be used (A 38).
- Initialize the SD card (A 41) when you use it with the camcorder for the first time.
- The LOCK switch on the SD card is set to prevent accidental erasure. Change the position of the LOCK switch.
- The SD card is full. Delete some clips (A 152) and photos (A 200) to free some space or replace the SD card.
- The folder and file numbers for MP4 clips and photos have reached their maximum value. Set [Other Functions] >
[File Numbering] to [Reset] and insert a new SD card.
Recording to and playing back from a recording media is slow.
- This may occur as clips and photos are recorded/deleted over time. Save your recordings (A 166) and initialize the
recording media (A 41).
The supplied wireless controller will not work.
- Set [Other Functions] > [Wireless Controller] to [On].
- Replace the battery of the wireless controller.
The optional RC-V100 Remote Controller or other commercially available remote control does not work.
- Make sure that [Other Functions] > [REMOTE Term.] is set to [RC-V100] when using the optional RC-V100 Remote
Controller or [Standard] when using a commercially available remote control.
- Turn off the camcorder, reconnect the RC-V100 or other remote control and then turn the camcorder back on again.
- A custom picture file saved in the camcorder must be selected to change custom picture settings using the remote
controller. Select a custom picture file from [C1] to [C9] (A 130).
COPY
… 223 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Canon XF200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Canon XF200 in the language / languages: English as an attachment in your email.

The manual is 23,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Canon XF200

Canon XF200 User Manual - German - 264 pages

Canon XF200 User Manual - Dutch - 248 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info