14
Preparation
Remote Control Battery Installation
To insure safe operation, please observe the following precautions :
– Use (2) AAA, SUM-4 or R03 type alkaline batteries.
– Replace two batteries at the same time.
– Do not use a new battery with a used battery.
– Avoid contact with water or liquid.
– Do not expose the remote control unit to moisture, or heat.
– Do not drop the remote control unit.
– If a battery has leaked on remote control unit, carefully wipe case clean and install new batteries.
– Risk of explosion if battery is replaced by an incorrect type.
– Dispose of used batteries according to the instructions.
Pull up and remove
the lid.
Remove the battery
compartment lid.
Slide the batteries into
the compartment.
Replace the compartment
lid.
Two AAA size batteries
For correct polarity (+ and
–), be sure battery
terminals are in contact
with pins in compartment.
1
2
3
Attaching the Lens Cover
Thread the string through the hole on the lens
cover and then tie a knot in the string to secure it
in place.
1
Thread the other end of the string through the
hole at the bottom of the projector. Then pass the
lens cover through the resulting loop of the string.
Tie a knot in the string to secure it in place.
2