212687
13
Zoom out
Zoom in
Previous page
1/20
Next page
Scanning Film
11
Scanning Film
This scanner can scan 35 mm film strips one frame at a time.
Preparing to Scan Film
Use the following procedures to place the Film Adapter Unit and the Film Guide on the document glass to
scan film.
1 Attach the cable for the Film Adapter Unit to the FAU
connector on the scanner’s back panel.
2 Open the document cover and place the Film
Guide on the document glass of the scanner.
Calibration
Calibration is required the first time the scanner is used to scan film. This procedure adjusts the scanner
output so that items are reproduced with the correct coloration. It is explained below using the example of
ArcSoft PhotoStudio and ScanGear CS in Simple Mode.
1 Remove the CAP from the Film Adapter Unit
and gently set the Film Adapter Unit over
the first frame in the Film Guide (frame
closest to the front).
Clean the document glass before placing the Film Guide on it, otherwise dirt and dust
can affect image quality or damage the film.
You cannot scan film with the scanner in the upright position.
If there is film in the Film Guide,
remove it before setting the Film
Adapter Unit on it.
Be careful not to lose the CAP or
to allow dirt into it.
Align the two film guide tabs
over the slots at the docume
n
glass edge and secure it with
the clip at the back.
Position the Film Adapter Unit
so that its alignment tab is
aligned with the Film Guide.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Canon lide80 scanner at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Canon lide80 scanner in the language / languages: English as an attachment in your email.

The manual is 2,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info