Do not drop the camera on Connect Station or touch the camera to it with
too much force. Doing so may damage Connect Station’s internal hard
disk.
Since the camera may not be recognized readily, hold it carefully close to
Connect Station while changing the camera’s position or angle.
Just holding the camera close to the Connect Station may not establish a
connection. In such a case, gently touch Connect Station with the
camera.
A connection cannot be established via the NFC function while shooting
with the camera, when the power switch is set to <k>, when there is no
card, or when the LCD monitor is closed with the screen facing inward.
When holding the camera close to the Connect Station, do not leave
anything between the camera and Connect Station. In addition, when a
case is attached to the camera, communication may not be possible via
NFC function.
When Battery Grip BG-E18 (sold separately) is attached, a connection
cannot be established via the NFC function.
If the camera and Connect Station are moved too far away from each
other while importing images, import may take time or the connection
may be terminated.
If the camera’s battery runs out during import, the import will stop.
Charge the battery, then try importing again.
A connection can be established even when the camera’s power is in the
auto power off state. However, if a connection cannot be established,
cancel auto power off, then establish a connection.
When all images are already imported, import does not start. In such a
case, select [OK] to terminate the connection.
When there are a large number of images on the memory card, it may
take time to check and save the images.
