Cautions for Setting Multi Shot Noise Reduction
If there is significant misalignment in the image due to camera shake, the
noise reduction effect may become smaller.
If you are handholding the camera, keep it steady to prevent camera
shake. Using a tripod is recommended.
If you shoot a moving subject, the moving subject may leave
afterimages.
Auto image alignment may not function properly with repetitive patterns
(lattice, stripes, etc.) or flat, single-tone images.
If the subject’s brightness changes as the four consecutive shots are
taken, irregular exposure in the image may result.
After shooting, it may take some time to record an image to the card after
performing noise reduction and merging the images. During the
processing of the images, “buSY” will be displayed in the viewfinder and
on the LCD panel, and you cannot take another picture until the
processing is complete.
You cannot use AEB and white balance bracketing.
If [z3: Long exp. noise reduction], [z3: Multiple exposure], [z3:
HDR Mode], AEB shooting, white balance bracketing, or Live View
shooting with Servo AF is set, [Multi Shot Noise Reduction] cannot be
set.
This cannot be set for bulb shooting.
Flash photography is not possible. Note that the AF-assist beam of EOS-
dedicated, external Speedlites will be emitted according to the [8C.Fn
II-6: AF-assist beam firing] setting.
[Standard] will be set automatically if you do any of the following: Setting
the power switch to <2>, replacing battery, replacing card, setting
shooting mode to other than <d>, <s>, <f>, or <a>, or switching
to movie shooting.
