331734
6
Zoom out
Zoom in
Previous page
1/68
Next page
6 -
INSTALLATION - RACCORDEMENT ELECTRIQUE
RACCORDEMENT AUX BORNES DE LA PLAQUE :
Pour procéder au raccordement, il est impératif de respecter les consignes citées ci-des-
sous.
. L'installation doit être protégée par un fusible approprié, voir tableau page 7, et doit
comporter des fils d'une section suffisante pour alimenter normalement l'appareil.
. Le câble d'alimentation doit être choisi en fonction des indications du tableau page 7.
Pour procéder au raccordement, il faut :
. retourner la table, face verre contre le plan de travail, en prenant soin de protéger le
verre !
. ouvrir le capot en suivant les étapes suivantes :
. repérer les deux languettes situées sur les côtés,
. placer la lame d'un tournevis à l'avant de chaque
languette, enfoncer et presser,
. soulever le capot.
. raccorder le câble d'alimentation :
. en respectant les indications du tableau page 7 et les marquages sur la plaque à
borne, mettre en place les barrettes shunts (les barrettes shunts, insérées dans la plaque à
bornes, permettent d'établir un pont entre deux bornes)
. dénuder l'extrémité de chaque conducteur et les fixer sur les bornes, en respectant
les indications mentionnées sur le tableau page 7,
. dévisser le serre-câble,
. passer le cordon dans le serre-câble.
Lorsque l'opération de raccordement aux bornes de l'appareil est terminé, revisser le
serre-câble et fermer le capot.
Nota : veiller à bien serrer les vis de la plaque à bornes.
PLAQUE A
BORNES
)
) Barrettes shunts
)x 3
)
)
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Candy pvd 604 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Candy pvd 604 in the language / languages: English, French as an attachment in your email.

The manual is 0,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info