2.1 SETTING THE CLOCK
•When the appliance is connected to the domestic power supply for the first time, or after a power cut,
four dashes will appear on the display (----).
In order to set the clock, proceed as described below:
33
CHAPTER 2 – USING THE CONTROLS AND MODES
Press the key (6).
(The hours flash on display 1)
1
Set the desired time by turn-
ing the knob (14).
(The hours flash on display 1)
2
Press the key (6) again.
(The minutes flash on display 1)
3
Set the desired minutes by
turning the knob (14)
(The minutes flash on display 1)
4
Press the key (6) again.
(The display shows the time set)
5
• If you wish to change the hour on the dial once it has been set, press the key (6) before proceeding
to set the new time as described above.
• It is possible to display the current time even after starting the mode set, by pressing the key (6) (the
time is displayed for 2 seconds).