621059
6
Zoom out
Zoom in
Previous page
1/198
Next page
0 EN6
Air Outlets in the Base
Adequate ventilation must be provided in the room where the tumble
dryer is located to prevent gases from appliances burning other fuels,
including open fires, being drawn into the room during operation of the
tumble dryer.
Installing the rear of the appliance close to a wall or vertical surface.
There should be a gap of at least 12 mm between the machine and any
obstrubtions.The inlet and outlet should be kept clear of obstruction.To
ensure adequate ventilation the space between the bottom of the
machine and the floor must not be obstructed.
Check regularly that the air flowing through the dryer is not restricted.
Check frequently the fluff filter after use, and clean, if necessary.
Prevent items from falling or collecting behind the dryer as these may
obstruct the air inlet and outlet
NEVER install the dryer up against curtains.
In cases where the dryer is installed on top of a washing machine, a
suitable stacking kit must be used according to the follow configuration.
-Stacking kit Mod 35100019: for minimum washing machine depth 49 cm
-Stacking kit Mod 35900120: for minimum washing machine depth 51 cm
The stacking kit shall be one of that above, obtainable from our spare
service.
The stacking kit shall be one of that above, obtainable from our spare
service.
The instructions for installation and any fixing attachments, are provided
with the staking kit.
Ventilation
0 EN6
Do not install the product in a low
temperature room or in a room where there is
a risk of frost occurring. At temperature
around freezing point the product may not be
able to operate properly: there is a risk of
damage if the water is allowed to freeze in
the hydraulic circuit (valves, hoses, pumps).
For a better product performance the
ambient room temperature must be between
+2°C and +35°C. Please note that operating
in cold condition (between +2 and +15°C)
might simply some water condensation and
water drops on floor.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Candy GVH D913A2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Candy GVH D913A2 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 27,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info