Manual Candy FPE 602 (page 15 of 92) (English, German, Dutch, French, Italian, Polish, Portuguese, Spanish)

621262

Zoom out

Zoom in

1/92

•This function is typically used with

“cooking time” function.

For example if the dish has to be

cooked for 45 minutes and needs

to be ready by 12:30, simply select

the required function, set the

cooking time to 45 minutes and the

end of cooking time to 12:30.

•At the end of the cooking set time,

the oven will switch off

automatically and an audible alarm

will ring.

•Cooking will start automatically at

11:45 (12:30 minus 45 mins) and

will continue until the pre-set end-

of-cooking-time, when the oven

will switch itself off automatically.

WARNING.

If the END of cooking is selected

without setting the length of

cooking time, the oven will start

cooking immediately and it will

stop at the END of cooking time

set.

15 GB

2.8 SERVICE CENTRE

Before calling the Service Centre

If the oven is not working, we recommend that:

you check that the oven is properly plugged into the power supply.

If the cause of the fault cannot be detected:

disconnect the oven from the mains, do not touch the oven and call the

after sales service.

Before calling the Service Centre remember to make a note of the

serial number on the specifications plate (see fig. On last page).

The oven is supplied with a guarantee certificate that ensures that it

will be repaired free of charge by the Service Centre

3.4 USE OF TOUCH CONTROL CLOCK PROGRAMMER

WARNING : the first operation to

carry out after the oven has been

installed or following the

interruption of power supply (this

is recognizable the display

pulsating and showing ) is

setting the correct time. This is

achieved as follows.

12:00

3.3 SETTING THE CORRECT TIME

To set the cooking time, turn dial one

complete revolution and then position the

index to the required time. When the time

has lapsed, the signal will ring for a few

seconds.

3.1 USING THE MINUTE TIMER

3. TIMER

3.2 USING THE END OF COOKING TIMER

This control enables to set the desired cooking

time (max. 120 min.) the oven will automatically

switch off at the end of the set time.

The timer will count down from the set time

return to the O position and switch off

automatically.

For normal use of oven set the timer to the

position.

To set the oven ensure the timer is not on the O

position.

•Push the central button 4 times

•Set time with buttons.

•Release all buttons.

"-" "+"

ATTENTION: The oven will only operate providing the clock is set.

FUNCTION

HOW TO ACTIVATE IT

HOW TO SWITCH ITOFF

WHAT IT DOES WHAT IT IS FOR

KEY LOCK

MINUTE

MINDER

COOKING

TIME

END OF

COOKING

•Child Lock function is

activated by touching Set (+)

for a minimum of 5 seconds.

From this moment on all other

function are locked and the

display will flash STOP and

preset time intermittently.

•Child Lock function is

deactivated by touching

touchpad Set (+) again for a

minimum of 5 seconds. From

this moment on all functions

are selectable again.

•Push the central button

1 times

•Press the buttons "-" "+"

to set the required time

•Release all the buttons

•When the set time as elapsed

an audible alarm is activated

(this alarm will stop on its own,

however it can be stopped

immediately by pressing the

button) SELECT.

•Sounds an alarm at the end of

the set time.

•During the process, the

display shows the remaining

time.

•Allows to use the oven as alarm

clock (could be activated either

with operating the oven or with

out operating the oven)

• Push the central button 2 times

• Press the buttons "-" or "+"to

set the lenght of cooking

required

• Release all buttons

• Set the cooking function with

the oven function selector

•When the time is elapsed the

oven will switch off

automatically.

Should you wish to stop cooking

earlier either turn the function

selector to 0, or set time to 0:00

(SELECT and "-" "+" buttons)

• It allows to preset the cooking

time required for the recipe

chosen.

• To check how long is left to run

press the SELECT button 2 Times.

• To alter/change the preset time

press SELECT and "-" "+"

buttons.

•Push any button to stop

the signal. Push the central

button to return to the clock

function

•At the time set, the oven

will switch off. To switch

off manually, turn the oven

function selector to

position O.

•Enables you to set the end of

cooking time

•To check the preset time p

•To modify the preset time

press buttons SELECT + "-" "+"

ush

the central button 3 times

•

•Press the buttons "-"

"+" to set the time at which you

wish the oven to switch off

•Release the buttons

•Set the cooking function with

the oven function selector

Push the central button 3

times

00:00

select

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Candy FPE 602 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 17,57 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Candy FPE 602 Manual

Product: