466038

Candy CVM5621KW Manual

9
Zoom out
Zoom in
Previous page
1/11
Next page
08 GB
To Replace the inside light
• Switch off the mains power supply and unscrew bulb.
Replace with an identical bulb that can withstand very high
temperatures.
• Never use steam or a vaporizer for cleaning.
CLEANING AND MAINTENANCE
Before all cleaning and maintenance :
•Disconnect mains voltage.
•If the oven is hot, wait till it has cooled down.
•Never use a steam or high pressure spray to clean the appliance.
•Never use abrasive cleaners, wire wool or sharp objects to clean
the glass oven door.
•Clean enamelled surfaces with warm, soapy
water or with
suitable brand products. On no account use abrasive powders
that may damage surfaces and ruin the appearance of the cooker.
It is very important to clean the oven each time it is used.
•Use detergents and abrasive metal pads for the stainless steel
grills.
•The glass surfaces such as the
top, the oven door and the
warming compartment door must be cleaned when they are cold.
•Damage caused by failure to respect this rule is not covered by
the guarantee.
•Do not use abrasive products, metal cleaning pads, sharp
objects, rough cloths, or chemical products and detergents that
can permanently damage
the catalytic lining.
•It is a good idea to use deep roasting trays for fatty foods such as
joints of meat etc. and to put a tray underneath the grill to catch
surplus fat.
Cleaning of Oven Door
For thorough cleaning of the oven door, it is advisable to remove
the same,
as shown in below.
Open the door completely, turn the two feet on the hinge arms
180º. Close the door partly by a 30º. Remove the door by slightly
lifting the it at this position.
For replacing the door, follow the steps above in the reverse order.
Before carrying out any maintenance
work on the hob, allow it to
cool down.
Only products, (creams and scrapers) specifically designed for
glass ceramic surfaces should be used. They are obtainable from
hardware stores.
Avoid spillages, as anything which falls on to the hob surface will
quickly burn and will make cleaning more difficult.
It is advisable
to keep away from the hob all substances which are
liable to melt, such as plastic items, sugar, or sugar-based
products.
MAINTENANCE
•Place a few drops of the specialised cleaning product on the hob
surface.
•Rub any stubborn stains with a soft cloth or with slightly damp
kitchen paper.
•Wipe with a
soft cloth or dry kitchen paper until the surface is
clean.
If there are still some stubborn stains
•Place a few more drops of specialised cleaning fluid on the
surface.
•Scrape with a scraper, holding it at an angle of 30 to the hob, until
the stains disappear.
•Wipe with a soft cloth
or dry kitchen paper until the surface is
clean.
•Repeat the operation if necessary.
A FEW HINTS
Frequent cleaning leaves a protective layer which is essential to
prevent scratches and wear. Make sure that the surface is clean
before using the hob again. To remove marks left by water, use a
few drops
of white vinegar or lemon juice.
Then wipe with absorbent paper and a few drops of specialised
cleaning fluid.
The control knobs can be removed for a complete cleaning.
However, you must care not to let any liquid go into the open
zones, and then to push the knobs fully on
fitting back.
The glass ceramic surface will withstand scraping from
flatbottomed cooking vessels, however, it is always better to lift
them when moving them from one zone to another
Do not use a sponge which is too wet.
Never use a knife or a screwdriver.
A scraper with a razor blade will not
damage the surface,
0
as long as it is kept at an angle of 30 .
Never leave a scraper with a razor blade within the reach of
children.
Never use abrasive products or scouring powders.
The metal surround
to safely clean the metal surround wash with soap and water,
rinse, then dry with a soft cloth.
CATALYTIC SELF - CLEANING OVEN
•Special self-cleaning panels covered in a micro-porous coating
are available on some of our models. If they are fitted, the oven no
longer needs to be cleaned by hand.
•The lining must be porous for self-cleaning to be effective.
•Excessive splattering of fat may block the pores and therefore
hinder self-cleaning. This
self-cleaning capacity may be restored
by switching on the empty oven to maximum for about 10-20
minutes.
•If the walls of the oven are so thickly coated in grease that the
catalytic lining is no longer effective, remove surplus grease with a
soft cloth or sponge soaked in hot water. All
catalytic linings
currently on the market have a working life about 300 hours. They
should therefore be replaced after about 300 hours.
30
°
Max
0
180
… 9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Candy CVM5621KW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Candy CVM5621KW in the language / languages: English as an attachment in your email.

The manual is 0,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Candy CVM5621KW

Candy CVM5621KW User Manual - Dutch, French - 26 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info