513764
16
Zoom out
Zoom in
Previous page
1/36
Next page
ENVIRONMENTAL INFORMATION
Packaging and waste treatment
After unpacking the appliance, do not throw the packaging in the garbage but separate
the various materials (such as styrofoam, cardboard. etc.) according to the local regula-
tions and procedures for waste disposal.
Important:
This appliance has been produced without CFCs. The refrigerating circuit contains HFC R
134a fluid, or alternatively, R 600a isobutane gas. For further details, look at the serial
number plate on the appliance.
When cleaning the appliance, use only the materials and the procedure specified in the
section dealing with cleaning. Otherwise the appliance may be damaged.
For appliances with isobutane (R 600 a)
Isobutane is a natural gas that does not harm the environment.
Isobutane is, however, flammable. You must therefore ensure that:
- when the appliance is installed there is more than 3 cubic metres of air around it;
- the appliance's ventilation vents are kept unobstructed and clean;
- the appliance's refrigerating circuit is not damaged neither internally, through the use of
sharp or pointed objects nor because the condenser unit was incorrectly cleaned.
At the end of the appliance's working life it must be stored before being disposed of. For
information on proper disposal of the appliance, consult your retailer or the local authority
responsible for disposal.
TEMPERATURE CONTROL
The ambient temperature, the load and the frequency with which the doors of the applian-
ce are opened all affect the internal temperature. When the control value is changed the
freezer cannot start up immediately because it has been halted. Temperature regulation
is done using the thermostat knob to be found outside the freezer.
By turning the knob clockwise lower temperatures are reached. It is recommended to keep
the thermostat knob at a mid point position and to increase it by a few numbers when the
freezer is opened frequently or when a lage quantity of food to be frozen is put in.
CONTROL PANEL Fig. 2
When the plug is inserted, the green light (B) lights up.
The thermostat A controls the freezer temperature.
On Position "" the freezer will not operate although the green light will still be on.
Turning the knob clockwise will start the appliance.
The red warning light (C) when lit up means that the temperature in the freezer compart-
ment is not adequate. This could depend on:
- When appliance is firstly plugged in.
- Door left open or not properly closed.
- Insertion of fresh food to be frozen in the freezer compartement.
- The red light goes off once the freezer compartment has reached the required temperature.
By turning the thermostat knob to "SUPER" the yellow light (D) will illuminate, indicating
that the fast freeze has been started making the compressor work continuously.
16
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Candy CV 300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Candy CV 300 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info