513774
10
Zoom out
Zoom in
Previous page
1/32
Next page
10
If the appliance is provided with a condenser on the external wall fig.1 (S), periodically remove any dust and dirt from it, since these
prevent heat being vented from the appliance.
The formation of ice and frost on the inside walls has a detrimental effect on the appliance's ability to chill, and should therefore be
removed periodically. For removal of frost and ice, adhere strictly to the manufacturer's recommendations.
DEFROSTING
To carry out defrosting proceed as follows:
- turn the thermostat to 0; fig.2 (A)
- unplug the appliance or switch off the domestic power supply at the main switch;
- remove all food from the freezer;
- remove the defrost water drain plug inside the compartment and on the outside of the housing, where provided.; fig.1 (Z)
- place a container next to the external drain outlet to collect the defrost water;
- dry the inside walls.
With normal use (the appliance is opened 3-4 times a day) the freezer should be defrosted once or twice a year.
Never use electrical appliances such as hairdryers, fan heaters or a naked flame for defrosting.
AFTER-SALES SERVICE
Only contact after-sales service if you are unable to solve the problem yourself with the help of the “Troubleshooting
guide/Causes/Solutions” (supplied with the appliance).
To facilitate the job of the after-sales service, before calling take note of the following information to identify your appliance:
Appliance brand;
Model/Type;
Type of problem;
Date of purchase;
Name of retailer;
TROUBLESHOOTING GUIDE/CAUSES/SOLUTIONS
Abnormal operation is not always caused by an actual malfunction of the appliance, but by incorrect installation or use. To avoid needless
call-outs and the relative bill for after-sales service, observe the following:
The appliance is not working
Check that:
The thermostat is not at 0.
The power plug is in good condition and properly inserted in the socket
There is no power cut.
The appliance does not freeze sufficiently
Freezing takes too long
The compressor runs too much
Check that:
The door is closed properly; fig.1 (A)
The thermostat is set to the correct position; fig.2 (A)
The freezer is not too near a heat source;
There is not an excessive build-up of frost in the low temperature compartment;
The appliance is too noisy
Check that:
The appliance is properly level;
The rear coil is not touching the wall; fig.1 (S)
Bear in mind that it is normal for the appliance to produce the following noises:
clicking noises caused by the compressor starting and stopping;
humming noises when the compressor begins running;
gurgling noises as the refrigerant gas flows through the pipelines, even once the compressor stops;
IMPORTANT!
The manufacturer declines all liability for injury to persons or animals and for damage to property resulting directly or indirectly
from failure to observe the procedures and reminders given in this instruction booklet.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Candy CHFA 190 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Candy CHFA 190 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info