714059

Candy CH64BVT Manual

10
Zoom out
Zoom in
Previous page
1/149
Next page
Automatic Safety Off
If the power level is not changed during a preset time, the
corresponding heater turns off automatically.
The maximum time a heater can stay on, depends on the selected
cooking level.
Power level
Max. time on (hours)
1
2
3
4
5
6
7
8
9
P
10
5
5
4
3
2
2
2
2
2
NOTE: while an overheating situation should occur during the
operation of the highest power levels, the Hob control will
automatically adjust the power level in order to protect the hob from
overheating.
7. CLEANING AND MAINTENANCE
If there are still some stubborn stains:
NB:
.MAINTENANCE:
Frequent cleaning leaves a protective layer which is essential to
prevent scratches and wear. Make sure that the surface is clean
before using the hob again. To remove marks left by water, use a few
drops of white vinegar or lemon juice. Then wipe with absorbent paper
and a few drops of specialised cleaning fluid.
The glass ceramic surface will withstand scraping from flat-bottomed
cooking vessels, however, it is always better to lift them when moving
them from one zone to another.
. Before carrying out any maintenance work on the hob, allow it to
cool down.
- Wipe with a soft cloth or dry kitchen paper until the surface is clean.
. Avoid spillages, as anything which falls on to the hob surface will
quickly burn and will make cleaning more difficult.
Do not use a sponge which is too wet.
- Wipe with a soft cloth or dry kitchen paper until the surface is clean.
- Repeat the operation if necessary.
. It is advisable to keep away from the hob all substances which are
liable to melt, such as plastic items, sugar, or sugar-based products.
- Place a few more drops of specialised cleaning fluid on the surface.
- Place a few drops of the specialised cleaning product on the hob
surface.
- Scrape with a scraper, holding it at an angle of 30° to the hob, until
the stains disappear.
- Rub any stubborn stains with a soft cloth or with slightly damp
kitchen paper.
AFEW HINTS:
. Only products, (creams and scrapers) specifically designed for
aglass ceramic surfaces should be used. They are obtainable from
hardware stores.
Never use a knife or a screwdriver.
A scraper with a razor blade will not damage the surface, as long
as it is kept at an angle of 30°.
Never leave a scraper with a razor blade within the reach of
children.
Never use abrasive products or scouring powders.
. The metal surround : to safely clean the metal surround wash with
soap and water, rinse, then dry with a soft cloth.
10 GB
30° Maxi
Any change in the colour of the glass-ceramic surface does
not affect its operation or the stability of the surface. Such
discolorations are mostly a result of burnt food residues or
use of cookware made of materials such as aluminium or
copper; these stains are difficult to remove.
8. PROBLEM SOLVING
Only use flat-bottomed pans. If light is visible between the pan and the
hob, the zone is not transmitting heat correctly.
Light surfaces on the hob
The cooking is too slow
Use a razor blade and follow the "CLEANING" section.
The pan bottom should fully cover the diameter of the selected zone.
Small scratches or abrasions on the hob's glass surface
Dark stains
The cooktop is not working.
Metal marks
Refer to the "CLEANING" section.
You use the correct materials, but the stains persist.
Marks from an aluminium or copper pan, but also mineral, water or
food deposits; they can be removed using the cream cleaner.
as the cooking zone.
Incorrect cleaning or rough-bottomed pans are used; particles like
grains of sand or salt get between the hob and the bottom of the pan.
Refer to the "CLEANING" section; make sure that pan bottoms are
clean before use and only use smooth bottomed pans. Scratches can
be lessened only the cleaning is done correctly.
Have a check made that the connection is done he control panel is
locked. Unlock the hob.
The hob does not operate or certain zones don't work
The control panel is locked. Unlock the hob.
The cooking zones do not simmer or only fry gently
Do not slide aluminium pans on the hob. Refer to the cleaning
recommendations.
Use a razor blade and follow the "CLEANING" section.
Unsuitable pans are being used. Only use flatbottomed utensils, that
are heavy and have a diameter at least the same
Caramelisation or melted plastic on the hob.
The shunts are not positioned correctly on the terminal board.
The hob does not cut off.
Frequency of on/off operations for cooking zones
The on-off cycles vary according to the required heat level:
- low level: short operating time,
- high level: long operating time.
The cooktop has turned itself off.
Display F and numbers
If and numbers appears in the display, your unit has detected a fault.
The following table list actions you can take to correct the problem.
F
Check the condition of the fuses / circuit breakers at your
location.Check to see if you are experiencing a power failure.
The main switch (ON/OFF key) was accidentally touched or there is
any object above any key. Turn the unit on again without any object
about the keyboard. Enter your settings again.
9. AFTERCARE
Before calling out a Service Engineer please check the
following:
— that the plug is correctly inserted and fused;
If the fault cannot be identified switch off the appliance — do not
tamper with it — call the Aftercare Service Centre. The appliance is
supplied with a guarantee certificate that ensures that it will be
repaired free of charge at the Service Centre.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Candy CH64BVT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Candy CH64BVT in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 12,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info