513749

Candy CD E701T Manual

22
Zoom out
Zoom in
Previous page
1/25
Next page
The softener unit is set in the factory at level 4 (D4) as this satisfies the requirements
of the majority of users. Regulate the setting of your water softener unit according to
the degree of hardness of your water as follows: keep the delay start button pressed
in and at the same time press the stop/start button .
The factory setting "D4" will appear on the display. To change the setting, press the
start delay button . Each time you press that button the setting will increase by
one level. When you have reached "D7", the display will go back to "D1".
When the required setting appears on the display, wait for an audible signal to
confirm that the new setting has been stored in memory.
43
Regulating the water softener
with electronic programmer
The water softener can treat water with a hardness level of up to 90°fH (French
grading) or 50°dH (German grading) through 8 settings.
The settings are listed in the table below:
Level
0
1
2
3
4
5
6
7
0-5
6-10
11-20
21-30
31-40
41-50
51-60
61-90
0-3
4-6
7-11
12-16
17-22
23-27
28-33
34-50
NO
YES
YES
YES
YES
YES
YES
YES
D1
D1
D2
D3
D4
D5
D6
D7
Water
hardness
°fH
(French)
Water
hardness
°dH
(German)
Use of
regenerating
salt
Water
softener
setting
DISPLAY
S
T
A
R
T
Pr
1
2
I
42
Activating and deactivating the audible signal
The audible signal function can be deactivated in the following way:
keep the “Programme Selection Button” (P) pressed in for a few
seconds and at the same time press the stop/start button ; if the
symbol "b1" appears on the display the audible signal is activated.
Press the “Programme Selection Button” (P) again and the symbol
"b0" will appear which means that the audible signal has been
deactivated.
An audible signal sounds to indicate that the setting has been stored in
memory.
Pr
I
Display shows E1.
Display shows E2.
Display shows E3.
Display shows E4.
PROBLEM CAUSE REMEDY
The Dishwasher is able to self-assess a number of problems. The problem will
be illustrated in the display window and by an audible signal.
Water supply switched off.
Problem with electronic temperature
control.
The Water Heater Element does not
work properly or the filter mesh is
blocked.
The appliance does not discharge
water.
Switch off appliance.
Turn on water supply.
Reset the cycle.
Call Service for assistance.
Clean the Filter Mesh and if the
problem continues please contact
Service.
Check :
• That the discharge hose is not
bent
• Syphon is not blocked
• Filters are not blocked
PROBLEMS AUTOMATICALLY SIGNED
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Candy CD E701T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Candy CD E701T in the language / languages: English, Danish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 0,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info