764895

Canadian Spa Company Toronto SE Manual

7
Zoom out
Zoom in
Previous page
1/24
Next page
TORONTO SE
Pre-Delivery Information
Access: Canadian Spa hot tubs are usually delivered on a at
bed trailer, up to 5 metres long, 2.4 metres wide and 3.5
metres high. Please ensure that there is adequate access for
such a vehicle to reach your property. When off loading from
our vehicle to the spa site, a minimum of 1100mm width is
required, (some models vary) this also needs to be at and a
minimum clear vertical height of 9ft should be considered also.
Electrical supply: If you are having your spa installed, it will
be necessary to have a dedicated electrical circuit supply
tted. You will require a 32 or 40 Amp (type C Breaker) supply,
dependent on the length from the service point. Your spa must
be protected via a RCD and suitable over current protection. A
minimum of 5 metres of cable is required for connection into
your spa from the Isolator.
Electrical installation: Arrange for a licensed electrician run
the required 230-volt power line to the spa installation site.
This power line must be permanently connected (hard-wired)
to the mains supply. Do not use extension cords or plug-in type
connections. At the site where the spa is to be located leave 5
metres of cable and the appropriate cable gland. All electrical
wiring to a spa must be installed by a qualied, licensed
electrician, and meet required electrical standards.
Water: The best means of lling your spa is with a garden
hosepipe (use cold water not hot water). Please ensure that
you have one readily available. If you are aware that your water
pressure is poor, we should be advised prior to delivery. The
design of our spas allows for easy drainage, again, using the
hosepipe which conveniently ts onto the drain valve situated
at the base of your spa. Ideally, you should empty the water to
a nearby drain. You may wish to purchase a suitable
submersible pump to speed up this process.
Decking around your spa: Ensure that you are aware of the
above measurements. Always consider during your planning
that any decking boards and supporting beams that you install
allow access to the sides of your Spa. It is the customers’
responsibility to ensure that any decking is clear of these areas
prior to any visit by our technicians (Allow 1 metre clearance
around your hot tub and if you have decking ensure part of
your decking can be removed in order to gain access for future
repair or servicing). If you are unsure then please ask before
ground construction and the delivery of your spa.
Your spa must be sited on a solid, at, level base which is the
same size or larger than the spa. The base can be either a 10-
15cm concrete slab or suitably strengthened timber decking
or existing patio area assuming it has suitable foundations of
hardcore. Whatever base area is chosen, it must be of suitable
load bearing capacity. Please ensure your base has suitable
drainage.
Preparing for the delivery of a hot tub:
• The site you select for your spa must be a at surface that
contacts the bottom of your spa completely.
• Spas weigh between 900kg and 1,400kg when full,
therefore a solid support is essential.
• The base needs to be at least the same size as the footprint
of your spa.
• The power supplied must be a dedicated RCD protected
circuit,
You will need to get a qualied electrician to undertake this
work.
A 10-15 cm
concrete base is
ideal preparation
for a hot tub.
Ensure part of your decking can be removed in order to gain access for future
repair or servicing
Optional Crane
Service is
available
(7)
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Canadian Spa Company Toronto SE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Canadian Spa Company Toronto SE in the language / languages: English as an attachment in your email.

The manual is 1,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info