764907
4
Zoom out
Zoom in
Previous page
1/32
Next page
Owners Manual
Introduction to your hot tub /spa
3
SPA SHELL: Surface of the spa that holds the water, constructed of
acrylic and fiberglass.
SPA SKIRT: Surrounding material that conceals the underside of the
spa shell and equipment bay. Also referred to as the ‘spa cabinet’,
‘cladding’ or ‘panels’.
ACCESS PANELS: Removable sections of the spa skirt located on the
operator side of the spa. The equipment bay, including pump(s) and spa
controller are located behind the access panels.
SPA CONTROLLER: Unit that controls spa operations, containing
electronic programming boards, heater and all connections for Pump(s),
Light(s), Ozone Generation Unit and Topside Console. Also referred to as
‘Spa Pack’ or ‘Controller’.
MASSAGE PUMP: Electro-mechanical device to move water,
consisting of a wet end and a motor.
OZONE GENERATOR: Device that generates ozone to aid in
maintaining water quality. Ozone helps eliminate organic material such
as body oils, dead skin cells and hair.
HEATER: Electrical resistance device located in the Spa Controller
containing the heating element and 2 temperature sensors. The flow
through heater heats the spa’s water as it flows across the heating
element. Heaters are available in several wattages.
TOPSIDE CONSOLE: Button pad and temperature display panel
located on the top of the spa into which various commands, control
sequences and options for operating the spa can be input. User can
set temperature, filtration cycle and heating mode through the console.
Consoles have various button configurations. Also referred to as the
‘Console’.
JET: Device that ejects air and water, creating water movement in the
spa.
AROMATHERAPY: A small canister that holds scented beads and
works conjunction with the air control system to create an aromatic
experience.
DRAIN VALVE: Valve located on the outside of spa cabinet used to drain
water from the spa. A garden hose can be attached to the drain valve.
EQUIPMENT BAY: Location under the spa shell covered by access
panels that houses the spa controller and equipment.
FILTER HOUSING: Assembly that holds the filter cartridge
(Note: configurations may differ from model to model).
FOOT WELL: Lowest portion of the spa where the suction fittings are
located.
OVERLAY: Decal covering the Topside Console, showing button
location for various spa operations.
SUCTION FITTING: Located at the bottom of the spa, used to return
water back into the filter and pump system.
AIR CONTROL: Device located on top side of spa used to turn on and
off air assist to the jets. One valve can operate up to 20 jets.
WATER DIVERTER: Device located on top side of spa and used to
change the direction of water flow within the space.
WATERFALL ON/OFF VALVE: Located on top rail of spa used to adjust
the waterfall flow.
SLICE VALVE: Two-position (open or closed) sliding valve, used to cut
off water flow which allows for service to be preformed on the spa
equipment without the need to drain the spa. Slice valve operations: up
for open, down (toward the valve body) for closed.
SPA COVER: Marine grade vinyl covering filled with rigid foam inserts
to cover the top of the spa. The spa cover is the most important item for
maintaining consistency of the spa water temperature and chemistry.
Halifax Kingston Alberta
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Canadian Spa Company Ontario 2016 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Canadian Spa Company Ontario 2016 in the language / languages: English as an attachment in your email.

The manual is 3,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info