Manual Camry CR 4488 (page 4 of 54) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish)

801596

Zoom out

Zoom in

1/54

1. Before cleaning, the device must be disconnected from the mains.

7. Pierce the fruit or candies with a wooden stick or fork and dip in chocolate.

9. Pour remaining chocolate from collecting tray (3) to separate container and clean the unit as soon as possible to do not let the

chocolate solidificate.

CLEANING AND MAINTENANCE

Technical data:

Power supply: 230V ~50Hz

Power: 320W

Capacity: 650 ml

6. Remove chocolate residue using a soft cloth.

4. Wash tower (1) and auger (2) in warm soap water by hands.

Maximum Temperature: 60°C

2. Place fountain tower (1) on 3 pins fixed on collecting tray (3)

5. Fill up the collecting tray (3) by ALREADY MELTED chocolate up to 0,5cm below its edge.

3. To keep ideal vertical position of device adjust the vertical position of device by adjustable front feet (6). If the device will be on slope

surface the chocolate will not flow out smoothly.

4. Switch on the unit to supply and turn on the device by turn the heating function knob (9) to position HEAT. Heating control lamp (5)

will be light up and the heating process will be started. Wait 3-5 minutes to let the unit to heat up properly.

5. Rinse the collecting tray (3) carefully with warm water several time and pay special attention to do not let the water come inside the

base (4) through knobs.

7. Clean exterior surfaces by slightly damp cloth and dry it.

6. Turn the Auger rotation knob (7) to position “MOTOR” to let the auger rotate. An auger (2) will transport the chocolate to the top and

let it to swim down through fountain tower (1) to collecting tray (3) again.

8. To stop the operation turn both knobs to OFF position. Switch off the plug. Remember the unit can be still hot.

2. Remember the unit can be still hot. Wait until the appliance has cooled down a little.

3. It is recommended to wash the device after each use when chocolate is still liquid.

INSTRUCTIONS FOR USE

CHOCOLATE MELTING. For best result, please melt the chocolate before pour to collecting tray (3). You can melt the chocolate in a hot

water bath: pour water to pot and start to heat up the water, next place the bowl with small pieces of chocolate on water . Remember to

mix from time to time. Do not heat up too much to avoid the grey color of chocolate after its cooling down. Alternative way to melt

chocolate is to heat up it in a microwave oven, time 1-5 minutes depends of quantity of chocolate.

4. Base 5. Heating control lamp 6. Front feet

7. Auger rotation knob 8. Roller 9. Heating function knob

DEVICE DESCRIPTION CHOCOLATE FOUNTAIN CR4488

BEFORE FIRST USE

1. Place base (4) on stable flat, surface. Place the plastic auger (2) on the roller (8).

1. Fountain tower 2. Plastic auger 3. Collecting tray

Prepare small whole fruit for dipping in chocolate: strawberries, grapes or smaller pieces of bananas, apples and other fruits. You can

also dip ice cream cones, biscuits, and foam candies in the chocolate.

CHOCOLATE CHOICE. To ensure best flow ability please use chocolate with high proportion of cocoa butter. The proportion of cocoa

should be 60% at least. If there is below 60%, it may be need to add some quantity of oil (e.g. Cocos oil). Chocolate suitable to use in

fountain chocolate contains of high proportion of cocoa butter, so it has good flow ability and normally does not require any oil. Standard

bar of chocolate contains too little cocoa butter, is therefore not very liquid and almost always requires additional oil. We recommend to

use special chocolate intended to apply in the chocolate fountains.

To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste

bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may

effect the environment. Do not dispose this appliance in the common waste bin.

DEUTSCH

only to power outlet with ground circuit. Device is compliant with EU directives:

- Low voltage directive (LVD)

- Electromagnetic compatibility (EMC)

Device marked CE mark on rating label

Device is made in class I of insulation and has to be connected

3. Wegen Vorsichtsmaßnahmen, sollten keine weiteren Geräte an den gleichen Stromkreis

angeschlossen werden.

4. Falls sich Kinder in der Nähe befinden, sollte bei der Nutzung des Gerätes spezielle

LESEN SIE AUFMERKSAM WICHTIGE ANWEISUNGEN BEZÜGLICH DER SICHERHEIT DER

BENUTZUNG BEWAHREN SIE DIESE FÜR DIE ZUKUNFT AUF

Bei Verwendung des Gerätes zu gewerblichen Zwecken werden die Garantiebedingungen

geändert.

1. Vor dem ersten Gebrauch, die Bedienungsanleitung lesen und die dort angegebenen

Hinweise beachten. Der Produzent trägt keine Verantwortung für Schäden, die aufgrund

von bestimmungswidriger Nutzung oder unsachgemäßer Bedienung entstanden sind.

2. Das Gerät ausschließlich an die Steckdose 230V ~50 Hz anschließen. Es darf nicht zu

anderen, bestimmungswidrigen Zwecken benutzt werden.

ALLGEMEINE SICHERHEITSVORSCHRIFTEN

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Camry CR 4488 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 3.63 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Camry CR 4488 Manual

Product: