Manual Campingaz Camp Bistro Stopgaz (page 9 of 64) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish)

662442

Zoom out

Zoom in

1/64

Lighting the burner (with STOPGAZ™ flame guard)

The equipment is fitted with a piezo-electric lighter

connected to an ignition electrode (6).

- Turn the control knob (1) anti-clockwise until you hear

a click ( ) indicating a spark (Fig. 7). Hold the knob in

this position for a few seconds to prime the flame guard

thermocouple. If the equipment does not light, turn

the control knob to position “l” (Fig. 9) and start the

operation again.

- If the equipment still does not light after three attempts,

turn the control knob to position “l” and check that the

cartridge contains gas (sound of liquid sloshing when

shaken) before starting the previous steps again. (If the

cartridge is empty, refer to paragraph D - Changing the

cartridge).

Cooking

Position the pan on the arms centred over the burner and

adjust the gas flow so that the flames do not burn higher

than the pan.

The size of the flame can be regulated by turning the

ignition knob (2) between the full flow position

( ) and medium flow position ( ).

Extinguishing

Turn the ignition knob (1) clockwise to “l” position (fig. 9).

D - CHANGING THE CARTRIDGE

The cartridge may be removed even if it is not empty.

Once your equipment has fully cooled:

- Check that the gas inlet is fully closed by turning the

control knob (1) clockwise to the “l” position (Fig. 9) and

that the burner (5) is extinguished.

- Disconnect the cartridge by putting the lever (2) in the

“UNLOCK” position.

- Open the cartridge compartment (3) and remove the

cartridge by lifting it from behind.

- Never throw away a cartridge which is not completely

empty, (check there is no liquid in the cartridge by shaking

it).

- Make sure that no food has dropped into and thus

obstructs the equipment regulator internal housing (fig.

4) before installing a new cartridge.

- Check that the seal is present and in good condition (fig. 4)

- Put in a new cartridge by following the instructions in

paragraph “B - PREPARATION FOR OPERATION - Installing

a CAMPINGAZ® cartridge CP250/ CP250 SP”.

Caution: If the cartridge is replaced while the appliance

is in use, do not touch the hot surfaces of the appliance

(burner, saucepan holder, plate...).

Caution: Some fuel may remain in the gas cock after the

unit has been turned off. For your safety, with the cartridge

lever (2) in “UNLOCK” position, turn ignition knob (1) to ( )

position to burn off any remaining fuel.

E - SAFETY DEVICE

Do not use an appliance which is leaking, damaged, or

which does not operate properly.

If the gas pressure in the cartridge is too high (for instance

overheating due to too large a surface on the cooking grill)

a built-in device disconnects the cartridge and the lever

(2) returns to “UNLOCK”. In this case, you need to remove

the cartridge and let it cool down (run it under water, for

example) before reusing it or use a new cartridge following

the instructions in Section “D - Changing the Cartridge”.

The unit will not operate until the gas pressure of the

cartridge returns back to the normal stove.

HOW TO RESET SAFETY DEVICE

- Turn the ignition knob (1) to the “l” position and raise

cartridge lever (2) up to the “UNLOCK” position.

- Remove the gas cartridge.

- Turn the ignition knob to the (

) position to release

excess gas in the gas cock.

- After 5 minutes, turn the ignition knob to the “l” position.

- Make sure the ignition knob is “l” and reset safety device

by:

a) Pushing the cartridge lever down to “LOCK” position,

and then

b) Pushing the cartridge lever up to “UNLOCK” position.

- Replace a new cartridge or a cooled down cartridge.

- Repeat the ignition procedure.

If the temperature in the cartridge is high initially, fuel will

not emerge even though the cartridge is installed in the

stove. This is due to the operation of the safety device. It is

not out of order.

STOPGAZ™ flame guard

The thermocouple placed in the flame (9) controls a valve

which automatically cuts off the gas intake to the burner

when this is extinguished (air draught or overflowing liquid,

for example). To relight it, follow the steps in paragraph C -

Lighting the burner (with STOPGAZ™ flame guard).

F - CLEANING AND STORAGE

In case of burn back (ignition under the burner

cap) switch the product off, allow it to cool down

(approximately five minutes), then reignite the

appliance. If the problem of burn back persists, then

please contact your local Campingaz® representative.

Once your equipment has fully cooled:

1 - Cleaning

Main equipment

- Clean the equipment having removed the cartridge.

- Clean the pan support (4) and the cartridge exterior and

cover (3) with warm water, then dry with a cloth.

Burner (5)

A dirty burner will clog the holes of the flame.

Clean the flame holes of burner head with a metal brush

Ignition Plug

lf it is wet, ignition will not be made. Make sure any water

is removed, and dry with a cloth.

2 - Storage and transportation

- Check that the lever (2) is in the UNLOCK position (Fig. 10).

- Always remove the gas cartridge from the product

during storage or transportation of the appliance.

- Store the equipment and the cartridge in a cool, dry and

well-ventilated area, out of reach of children. Never store

in a basement or cellar.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Campingaz Camp Bistro Stopgaz in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Campingaz Camp Bistro Stopgaz Manual

Product: