662443
6
Zoom out
Zoom in
Previous page
1/7
Next page
6
D - CHANGING THE CARTRIDGE
The cartridge may be removed even if it is not
empty.
Once your stove has fully cooled:
- Check that the gas inlet is fully closed by
turning the control knob (1) clockwise to the
position (Fig. 9) and that the burner (5) is
extinguished.
- Disconnect the cartridge by putting the lever
(2) in the “UNLOCK position.
- Open the cartridge compartment (3) and
remove the cartridge by lifting it from
behind.
- Never throw away a cartridge which is not
completely empty, (check there is no liquid
in the cartridge by shaking it).
- Make sure that no food has dropped into and
thus obstructs the stove regulator internal
housing (g. 4) before installing a new
cartridge.
- Check that the seal is present and in good
condition (g. 4)
- Put in a new cartridge by following the
instructions in section “B - PREPARATION
FOR OPERATION - Installing a CAMPINGAZ®
cartridge CP250/ CP250 SP”.
Caution: If the cartridge is replaced while the
stove is in use, do not touch the hot surfaces of
the stove (burner, saucepan holder, plate...).
Caution: Gas residue may remain in the stove
after the stove has been turned o. For your
safety, with the cartridge lever (2) in “UNLOCK”
position, turn ignition knob (1) to (
) position
to burn o any remaining fuel.
E - SAFETY DEVICE
Do not use a stove which is leaking, damaged,
or which does not operate properly.
If the gas pressure in the cartridge is too high
a built-in device disconnects the cartridge and
the lever (2) returns to “UNLOCK”. In this case,
you need to remove the cartridge and let it cool
down (run it under water, for example) before
reusing it or use a new cartridge following
the instructions in Section “D - Changing the
cartridge. The stove will not operate until the
gas pressure of the cartridge returns back to the
normal stove
.
HOW TO RESET SAFETY DEVICE
- Turn the ignition knob (1) to the
position
and raise cartridge lever (2) up to the
“UNLOCK position.
- Remove the gas cartridge.
- Turn the ignition knob to the (
) position to
release excess gas in the gas cock.
- After 5 minutes, turn the ignition knob to the
position.
- Make sure the ignition knob is
and reset
safety device by:
a) Pushing the cartridge lever down to
“LOCK position, and then
b) Pushing the cartridge lever up to
“UNLOCK position.
- Replace a new cartridge or a cooled down
cartridge.
- Repeat the ignition procedure.
If the temperature in the cartridge is high
initially, fuel will not emerge even though the
cartridge is installed in the stove. This is due to
the operation of the safety device. It is not out
of order.
F - CLEANING AND STORAGE
Once your stove has fully cooled:
1 - Cleaning
Main stove
- Clean the stove having removed the
cartridge.
- Clean the pan support (4) and the cartridge
exterior and cover (3) with warm water, then
dry with a cloth.
Burner (5)
A dirty burner will clog the holes of the ame.
Clean the ame holes of burner head with a
metal brush
Piezo ignition electrode
If the electrode gets wet, the stove will not light.
Make sure any water is removed, and dry with a
cloth.
2 - Storage and transportation
- Check that the lever (2) is in the UNLOCK
position (Fig. 10).
- Always remove the gas cartridge from the
stove during storage or transportation.
- Store the stove and the cartridge in a cool,
dry and well-ventilated area, out of reach of
children. Never store in a basement or cellar.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Campingaz Camp Bistro 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Campingaz Camp Bistro 2 in the language / languages: English as an attachment in your email.

The manual is 1,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Campingaz Camp Bistro 2

Campingaz Camp Bistro 2 User Manual - All languages - 76 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info