662443

Campingaz Camp Bistro 2 Manual

9
Zoom out
Zoom in
Previous page
1/76
Next page
9
Cooking
Position the pan on the arms centred over the burner
and adjust the gas flow so that the flames do not burn
higher than the pan.
The size of the flame can be regulated by turning
the ignition knob (1) between the full flow position
( ) and medium flow position ( ).
Extinguishing
Turn the ignition knob (1) clockwise to “l” position (fig. 9).
D - CHANGING THE CARTRIDGE
The cartridge may be removed even if it is not empty.
Once your stove has fully cooled:
- Check that the gas inlet is fully closed by turning the
control knob (1) clockwise to the “l” position (Fig. 9)
and that the burner (5) is extinguished.
- Disconnect the cartridge by putting the lever (2) in the
“UNLOCK” position.
- Open the cartridge compartment (3) and remove the
cartridge by lifting it from behind.
- Never throw away a cartridge which is not completely
empty, (check there is no liquid in the cartridge by
shaking it).
- Make sure that no food has dropped into and thus
obstructs the stove regulator internal housing (fig. 4)
before installing a new cartridge.
- Check that the seal is present and in good condition
(fig. 4)
- Put in a new cartridge by following the instructions
in section “B - PREPARATION FOR OPERATION -
Installing a CAMPINGAZ
®
cartridge CP250/ CP250 SP”.
Caution: If the cartridge is replaced while the stove is in
use, do not touch the hot surfaces of the stove (burner,
saucepan holder, plate...).
Caution: Gas residue may remain in the stove after the
stove has been turned off. For your safety, with the
cartridge lever (2) in “UNLOCK” position, turn ignition
knob (1) to ( ) position to burn off any remaining fuel.
E - SAFETY DEVICE
Do not use a stove which is leaking, damaged, or which
does not operate properly. If the gas pressure in the
cartridge is too high, a built-in device disconnects the
cartridge and the lever (2) returns to “UNLOCK”. In this
case, you need to remove the cartridge and let it cool
down (run it under water, for example) before reusing
it or use a new cartridge following the instructions in
Section “D - CHANGING THE CARTRIDGE”.
The stove will not operate until the gas pressure of the
cartridge returns back to the normal.
HOW TO RESET SAFETY DEVICE
- Turn the ignition knob (1) to the “l” position and raise
cartridge lever (2) up to the “UNLOCK” position.
- Remove the gas cartridge.
- Turn the ignition knob to the (
) position to release
excess gas in the gas cock.
- After 5 minutes, turn the ignition knob to the “l”
position.
- Make sure the ignition knob is “l” and reset safety
device by:
a) Pushing the cartridge lever down to “LOCK” position,
and then
b) Pushing the cartridge lever up to “UNLOCK” position.
- Replace a new cartridge or a cooled down cartridge.
- Repeat the ignition procedure.
If the temperature in the cartridge is high initially, fuel will
not emerge even though the cartridge is installed in the
stove. This is due to the operation of the safety device.
It is not out of order.
F - CLEANING AND STORAGE
In case of burn back (ignition under the burner
cap) switch the stove off, allow it to cool down
(approximately five minutes), then reignite the stove.
If the problem of burn back persists, then please
contact your local Campingaz
®
representative.
Once your stove has fully cooled:
1 - Cleaning
Main stove
- Clean the stove having removed the cartridge.
- Clean the pan support (4) and the cartridge exterior
and cover (3) with warm water, then dry with a cloth.
Burner (5)
A dirty burner will clog the holes of the flame.
Clean the flame holes of burner head with a metal brush
Piezo ignition electrode (6)
If the electrode gets wet, the stove will not light. Make
sure any water is removed, and dry with a cloth.
2 - Storage and transportation
- Check that the lever (2) is in the UNLOCK position
(Fig. 10).
- Always remove the gas cartridge from the stove
during storage or transportation.
- Store the stove and the cartridge in a cool, dry and
well-ventilated area, out of reach of children. Never
store in a basement or cellar.
GB
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Campingaz Camp Bistro 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Campingaz Camp Bistro 2 in the language / languages: All languages as an attachment in your email.

The manual is 3,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Campingaz Camp Bistro 2

Campingaz Camp Bistro 2 User Manual - English - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info