120877
7
Zoom out
Zoom in
Previous page
1/14
Next page
3
1
Drill a hole about 2 cm
(1 inch) deep into wall.
2
Tap plastic anchor into hole
until it is flush with wall.
3
Screw a M5 x 25 mm screw
into anchor, leaving about
0.5 cm (¼ inch) protruding.
5
Slip keyhole slot of each
rear Satellite onto protruding
screw.
4
Apply rubber
pads on the
back of each
rear Satellite.
1
Thread Speaker Cable
through hole in Stand.
3
Insert attachment arm into socket
at back of Satellite.
5
Apply Identification Label
to back of Satellite.
4
Apply Identification
label to Speaker
Cable.
2
Push back red tab on Satellite.
Insert bare end of red-banded
cable into hole and release tab to
lock. Repeat for unmarked cable;
insert into black tab.
Attachment arm.
Mount the rear Satellites only on walls that are structurally sound.
Position the Satellites behind you and slightly above ear level.
Jupiter020800.fm Page 3 Thursday, August 3, 2000 8:26 AM
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cambridge SoundWorks DTT2200 5-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cambridge SoundWorks DTT2200 5-1 in the language / languages: English as an attachment in your email.

The manual is 3,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info