Manual Cambridge Audio one (page 10 of 13) (English)

160627

Zoom out

Zoom in

1/13

Operating instructions

Once all the required input and output connections are made, the One can be

switched on using its rear panel Power switch and front panel or handset Standby/

On button.

Either front panel or handset buttons can be used for the majority of the One

control functions.

To use the One as a conventional CD player, proceed as described in the following

paragraphs:

Loading and playing CDs

This unit has been designed to play compact discs, recordable

CDs (CD-R) and re-writable CDs (CD-RW) bearing the identication

logo shown here. No other discs can be used. Any CD-R/CD-RW

discs should contain properly recorded TOC (Table of Contents)

information so that they can be played back. This unit can play

only the discs recorded in the CD-DA format designed for music reproduction. Do

not attempt to play a disc containing other data, such as a CD-ROM for PCs with

MP3 or WMA les, on this unit.

Compatible bitrates

MP3 – 96, 128, 192, 256 and 320 kbps.

WMA – 48, 64, 96, 128, 160 and 192 kbps.

1. Select CD mode or load the disc into the CD slot. Once the disc is loaded, the

source will automatically switch to CD mode.

2. The disc will automatically start playing from the beginning of the rst track.

When the last track has nished playing, the unit will go to Standby mode.

3. To stop the disc at any point, press the Stop button. Pressing the Pause button

while the disc is playing will pause the disc. When the disc is paused the display

will ash, play can be resumed by pressing the Pause button again.

4. To eject disc, press the Stop button to stop the play back and press again to

eject the disc.

IMPORTANT!:

– Do not put anything except a compatible disc into the disc slot. Foreign objects

may damage the mechanism.

– If a disc is seriously scratched or dirty the player may not be able to read or

play it.

– Never load more than one disc at a time into the disc slot.

– Once the disc is ejected from the disc slot, do not push the disc back inside

while the disc is in the slot. To re-insert the disc, take the disc out of the slot and

put back into the slot.

Playing a specific CD track

With the One switched on and a disc loaded, specic tracks can be selected for

playback by pressing one of the front panel or handset   buttons to step

through the tracks on the disc forwards or backwards. When the desired track is

shown on the One display, press the front panel or handset Play button to begin

playback. The disc will then play from the selected track to the end.

Note: The numerical buttons on the remote can be used for playing specic track.

Scanning within tracks

With the One switched on and a disc playing, a specic point in a track can be

found by pressing and holding one of the front panel or handset Scan buttons to

fast-forward or fast-reverse through the track. When the desired point in the track

is reached the button can be released. The disc will then play from the selected

point to the end.

Repeating discs and tracks

With the One switched on and a disc playing, either a specic track or an entire

disc can be set to repeat indenitely. To repeat a specic track press the handset

Repeat button once while the track is playing. The One display will show "Repeat

Track". To repeat an entire disc simply press the handset Repeat button twice in

quick succession. The One display will show "Repeat All". Track or disc repeat can

be cancelled by a further press of the Repeat button, by pressing the front panel or

handset Stop button or by opening the disc drawer.

Playing tracks randomly

With the One switched on and a disc loaded, the tracks can be played randomly.

To select random play simply press the handset Random button once and then

the Play button. Random play can be cancelled by a further press of the Random

button. The disc will then continue to play the tracks in the "correct" order following

the track that was playing when random play was cancelled.

Programming disc play

The order in which CD tracks are played can be programmed with a playlist. Tracks

can also be suppressed from a playlist or programmed to play more than once.

With the One switched on and a disc loaded, press the handset Prog button. The

One display will show the Program menu. Use the front panel or handset  

buttons to step through the disc to the track you wish to be the rst track in the

playlist. Press the Select button on the remote to conrm the rst track. Repeat this

procedure for all the tracks required in the playlist and then press the front panel

or handset  button to store the programmed playlist. When the playlist is stored,

use the front panel or handset  button to play the programmed playlist.

The front panel or handset ,   and 

 functions can be used as normal

while a programmed playlist is playing. Press the front panel or handset  button

once to stop playback without deleting the playlist, or press it twice both to stop

playback and delete the playlist.

DAB/FM Tuner

Press the Standby/On button. Press either the FM or DAB source button.

FM mode

To tune and listen to stations, do the following:

1. Press the  button to scan up to the next available station.

2. Press the  button to scan to previous available station.

Note: For manual tuning, press and hold either of the   buttons. This will step

the frequency by 0.05MHz.

DAB mode

When selecting DAB mode for the very rst time, the unit will initiate a 'Full Service

Scan' for DAB services (can take up to 3 minutes to complete). A scanning bar

appears on the display while scanning for stations. When scanning is completed,

the unit will default to the DAB source mode. Use the   buttons to cycle through

receivable stations.

A partial or full scan for DAB station scan also be initiated at any time in the future

(see later section).

Press Enter to tune to and listen to the selected station.

Note:

– When scrolling through stations, as default the unit will revert to the previous

station if no station is selected or button pressed for 3-4 seconds. The One can

also automatically tune to any displayed station after 3-4 seconds of inactivity if

required. When in DAB mode press and hold the front panel or remote control

/ control. After 4 seconds an "Auto Enter On" or "Auto Enter Off" message will

be displayed. Press / to repeatedly toggle between these two settings then

either press no button for a few seconds or press in the Volume/Select control

to exit and save the setting.

– The number of DAB stations received will depend on aerial signal strength. We

recommend completing a full auto scan from time to time to pick up new DAB

stations.

– In DAB mode you can also press the Menu button which will rst bring up a

<Station Select> menu item. This also allows you to scroll to and select any

desired station using the volume control.

DAB settings

It is possible to change the DAB region setting for this unit. This is necessary if the

unit has been moved to a different region location.

Note: Changing the DAB region will erase all the stored DAB presets.

1. Press the Menu button on the remote to go to the menu settings.

2. Use the   buttons and select 'Tuner Setup > Tuner Region'. Press the Select

button to change the tuner region settings.

3. Use the   buttons to browse through the available country DAB region setting

Europe, Korea, USA, Australia, Canada, China and Taiwan.

4. Select the correct region and press the Select button to accept the new changes.

5. Restart the unit and perform a full station scan.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Cambridge Audio one in the language / languages: English as an attachment in your email.

The manual is 2,23 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cambridge Audio one

Cambridge Audio one User Manual - German - 24 pages

Cambridge Audio one User Manual - Dutch - 24 pages

Cambridge Audio one User Manual - French - 14 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Cambridge Audio one Manual

Product: