12
56
Power
Switches the unit on and off.
Disc tray
DVD/Compact Disc tray. Use the Open/Close button to activate.
IR sensor
Receives IR commands from the supplied remote control. A clear
unobstructed line of sight between the remote control and the sensor is
required.
Display
Used to display the DVD99’s functions and playback state etc.
Open/Close
Allows you to open and close the disc tray for loading of discs. Pressing
Play will also close the tray and start playing a disc if one is loaded.
Play/Pause
Plays the disc and pauses (freezes) play when playing.
Stop
Press once to stop playback. Pressing Play will cause the playback to be
re-started from the same position. Press again to fully stop playback.
Upscale
When playback is completely stopped press to switch the video output
resolution. Select the resolution that produces the best picture quality
on your TV. For most flat panels and DLP™, LCD or LCoS (SXRD™, D-
ILA™) rear projection televisions this will be 720p. For CRT rear
projection televisions this will likely be 1080i. For non HD displays (very
rare if they have HDMI or DVI) this will be 480p.
USB port
Port for interfacing to a flash/memory card or "Mass Storage Device".
Notes:
• Only USB 2.0 certified products with the USB 2.0 logo on them are
supported by the DVD99. Please either consult the manufacturer of
the USB 2.0 product to make sure it is properly certified, or go to
www.usb.org for a list of approved products, before purchase. We
cannot be held responsible for any incompatibility issues.
• This unit supports "USB Mass Storage Class Bulk-Only Transport"
devices only. Most USB thumbs drives, portable hard disk drives and
card readers conform to this device class. Other USB devices such as
MP3 players, digital cameras, and mobile phones may not be
compatible.
• Supported USB drives must be formatted with the FAT (File Allocation
Table) or FAT32 file system. Drives formatted with NTFS file system are
not supported.
1
2
3
4
5
6
7
8
9
7 8
910
43
The DVD99 is supplied with a
remote control. Insert the 2
supplied AAA batteries to activate.
For further details of the various
adjustment functions available,
refer to the later sections of this
manual.
Standby/On
Switches the unit between On
and Standby mode.
Eject
Opens and closes the disc tray.
Numerical buttons
Press the number of a desired
chapter or track to go directly to it.
For a number greater than ten,
press 10+ followed by the
number(s) required.
Go To
Press once to access Chapter
Selection then enter the required
chapter via the numerical
buttons. Press twice to access
Disc Time Selection and enter the
required time from the start of the
disc as H:MM:SS (Hours, Minutes,
Seconds). Press three times to
access Chapter Time Selection
and enter the required time from
the start of the chapter.
Resolution indicators
Indicates which HDMI resolution is in use:
1080p - Upscaled at 1080 lines progressive
1080i - Upscaled at 1080 lines interlaced
720p - Upscaled at 720 lines progressive
480/576 - Native NTSC/PAL resolution
10
