656745
6
Zoom out
Zoom in
Previous page
1/16
Next page
Rear panel connections cont.
12
Unbalanced Audio Output
A conventional RCA phono stereo output for connection to the line-level
inputs of an amplier. Use a high quality stereo RCA phono interconnect
cable intended for analogue audio signals.
13
Balanced Audio Output
The 851D features balanced outputs on two XLR sockets. Balanced
outputs provide slightly better audio performance and can reject cable-
borne noise and interference when used with equipment with balanced
inputs.
Note: XLR connectors should be wired as follows:
Pin 1: Ground
Pin 2: Hot (in-phase)
Pin 3: Cold (phase-inverted)
6
Front panel controls
44.1kHz
Input 1
Input 2
Input 3
Input 4
BNC
AES/EBU
BTooth
USB
1
Standby/On
Switches the unit between Standby mode (indicated by dim power LED)
and On (indicated by bright power LED). Standby is a low power mode
where the power consumption is less than 0.5 Watts. The unit can be left
in Standby mode when not in use.
2
Headphone connection
Allows for the connection of headphones with a ¼" jack plug connector.
Note: 600 Ohm headphones will work well on the 851D. However, with
some less sensitive models maximum volume maybe limited. If louder
listening is required, a lower impedance / higher sensitivity set of
headphones is recommended.
3
Menu
Press to enter the 851D's setup menus. Various 851D operating
parameters can be congured. Refer to the 'Operating instructions'
section for more information.
4
Filter
The different digital lters can be selected from the 851D’s setup
menu. Alternatively, pressing the Filter/
ø button on the remote will cycle
through different digital lter phase modes: Linear, Minimum, Steep,
Linear inverted, Minimum inverted and Steep inverted. Alternative digital
lters can offer subtly different sound quality characteristics. See later
section for further details. The currently selected lter is displayed by the
indicators just above the button.
Phase
Press the Filter button on the remote to cycle through different phase
output.
If you suspect that your source material or amplier, etc., is inverting the
phase of the musical signal, you can use this function to re-invert the
audio and regain absolute positive phase by pressing the phase button
in the setup menu. Alternatively, to select using the remote control, cycle
through the modes as described above.
5
Infrared sensor
Receives IR commands from the supplied Azur remote control. A clear
unobstructed line of sight between the remote control and the sensor
is required.
6
&
8
Source select buttons
Push the appropriate input selection button to select the source
component that you wish to listen to (highlighted by a solid circle on the
display).
7
Display
LCD used to control the 851D. Please refer to the 'Operating instructions'
and 'Settings' section of this manual for more information.
9
Volume
When Pre-amp mode is enabled, use to increase/decrease the level of
the sound from the outputs of the pre-amplier. This control affects the
level of the analogue audio output, and the headphones output. It does
not affect the digital output connections
Please refer to the 'Operating instructions' section of this manual for
more information on some of the functions of these buttons.
1 2 3
4
5
86
7
9
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cambridge Audio AZUR 851D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cambridge Audio AZUR 851D in the language / languages: English as an attachment in your email.

The manual is 8,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cambridge Audio AZUR 851D

Cambridge Audio AZUR 851D User Manual - German - 16 pages

Cambridge Audio AZUR 851D User Manual - Dutch - 16 pages

Cambridge Audio AZUR 851D User Manual - French - 16 pages

Cambridge Audio AZUR 851D User Manual - Italian - 16 pages

Cambridge Audio AZUR 851D User Manual - Polish - 16 pages

Cambridge Audio AZUR 851D User Manual - Swedish - 16 pages

Cambridge Audio AZUR 851D User Manual - Spanish - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info