763796
8
Zoom out
Zoom in
Previous page
1/12
Next page
38
840E
840W
Conexiones estéreo con dos cables
El siguiente diagrama muestra el modelo 840W conectado a un
preamplificador 840E, conectado a su vez a un par de altavoces
mediante doble cableado.
IMPORTANTE: La tira metálica que conecta los terminales de baja
frecuencia a los de alta frecuencia debe desconectarse cuando se trate
de un sistema con dos cables.
Nota: En esta configuración, debe establecerse el modo estéreo para el
modelo 840W.
On Off
Loop OutputInput
Balanced Audio - Right Unbalanced
Audio - Right
Input
Loop Output
Input
Loop Output
Out
Control Bus
Trigger
IR Emitter
In
Out/Thru
In
In
Loop OutputInput
Balanced Audio - LeftUnbalanced
Audio - Left
azur 840W Class XDTM Power Amplifier
Power Rating: 220 - 230V AC ~ 50/60Hz
Max Power Consumption: 2400W
www.cambridge-audio.com
Designed in London, England
Power AC
Please ensure that loudspeaker terminals are fully tightened
Veuillez s'assurer que les bornes de l'enceinte sont entièrement serrées
Stereo
Mono
Bi-Amp
Bridged
Loudspeaker Terminals - Right
Impedance 4 - 8 ohms
Bridged
Bridged
only!
Please ensure that loudspeaker terminals are fully tightened
Veuillez s'assurer que les bornes de l'enceinte sont entièrement serrées
Loudspeaker Terminals - Left
Impedance 4 - 8 ohms
Bridged
only!
Manufactured in an ISO9001 approved facility
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference
2) This device must accept any interference, including interference that may cause undesired operation
N1863
46
1 = Ground
2 =
3 =
In Loop
1 = Ground
2 =
3 =
In Loop
Balanced Balanced
Unbalanced
Left
Input Type
Balanced
Unbalanced
Right
Input Type
IMPORTANT!
Only change modes
when unit is off.
Refer to Manual for
more information.
Use Left Input for
Bridged / Bi-Amp
operation.
Mono Mode
Class 2 WiringClass 2 Wiring
CAUTION
Risk of electric
shock.
Do not open.
AVIS
Risque de choc
electrique.
Ne pas ouvrir.
ACHTUNG
Vorm öffnen
des gerätes.
Netzstecker ziehen.
R
L
R
L
R
L
IR1
IR2
IR3
IR4
Keypad 1
Keypad 2
Multi-Room
IR Emitter
In
Trigger
In Out/Thru In Out
LeftRight
Rec Out 2
Sub Out
Rec Out 1Rec InInput 7Input 6Input 5Input 4Input 3Input 2Input 1
Rec Out 2 Rec Out 1 Rec In Input 7 Input 6 Input 5 Input 4 Input 3 Input 2 Input 1
(Unbalanced) (Unbalanced)
Pre Out
Pre Out LeftRight
Balanced Pre Out
LeftRight
RS232C
Control Bus
PSU
In
International Patent Pending
LeisureTech Electronics Pty Ltd
GND
Power AC
On Off
Power
azur 840E Pre-Amplifier
Power Rating: 220 - 230V AC ~ 50/60Hz
Max Power Consumption: 36W
Designed in London, England
Flat / 200Hz L.P.
Manufactured
in an ISO9001
approved facility This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference; 2) This device must accept any interference, including interference that may cause undesired operation.
Input 2 Balanced Audio
Balanced
Unbalanced
Balanced
Unbalanced
Input 1 Balanced Audio
Input 1
Input 2
GND
CAUTION
Risk of electric
shock.
Do not open.
AVIS
Risque de choc
electrique.
Ne pas ouvrir.
ACHTUNG
Vorm öffnen
des gerätes.
Netzstecker ziehen.
R
L
www.cambridge-audio.com
Conexiones avanzadas
Al igual que con el funcionamiento normal estéreo con un cable(balanceado o no balanceado), también son posibles otros modos de funcionamiento:
estéreo con dos cables, monofónico con doble amplificador y monofónico con puente, entre otros.
En todos los ejemplos que se muestran a continuación, se pueden utilizar tanto conexiones balanceadas como no balanceadas, ya que la idea es
exactamente la misma para cada tipo de conexión. Para simplificar, solo mostraremos las conexiones balanceadas en cada ejemplo.
Sincronización de la potencia (control del encendido y del modo espera)
Al entrar y salir del modo espera, el preamplificador Azur 840E puede,
si lo desea, controlar automáticamente el amplificador 840W cuando
esté conectado a través de las conexiones del bus de control (las
conexiones del bus de control son las naranjas del panel trasero de los
modelos Azur compatibles). Para que esta característica funcione, las
unidades deben estar conectadas entre sí con cables RCA/phono. No
es necesario realizar ninguna otra configuración.
Conecte la salida del bus de control del preamplificador 840E a la
entrada del bus de control del amplificador 840W. A continuación,
conecte los demás modelos Azur si es necesario sincronizar más
unidades (consulte el manual del modelo 840E para obtener más
información, ya que será necesario realizar otras configuraciones).
R
L
R
L
R
L
IR1
IR2
IR3
IR4
Keypad 1
Keypad 2
Multi-Room
IR Emitter
In
Trigger
In Out/Thru In Out
LeftRight
Rec Out 2
Sub Out
Rec Out 1Rec InInput 7Input 6Input 5Input 4Input 3Input 2Input 1
Rec Out 2 Rec Out 1 Rec In Input 7 Input 6 Input 5 Input 4 Input 3 Input 2 Input 1
(Unbalanced) (Unbalanced)
Pre Out
Pre Out LeftRight
Balanced Pre Out
LeftRight
RS232C
Control Bus
PSU
In
International Patent Pending
LeisureTech Electronics Pty Ltd
GND
Power AC
On Off
Power
azur 840E Pre-Amplifier
Power Rating: 230V AC ~ 50Hz
Max Power Consumption: 36W
Designed in London, England
Flat / 200Hz L.P.
Manufactured
in an ISO9001
approved facility This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference; 2) This device must accept any interference, including interference that may cause undesired operation.
Input 2 Balanced Audio
Balanced
Unbalanced
Balanced
Unbalanced
Input 1 Balanced Audio
Input 1
Input 2
GND
CAUTION
Risk of electric
shock.
Do not open.
AVIS
Risque de choc
electrique.
Ne pas ouvrir.
ACHTUNG
Vorm öffnen
des gerätes.
Netzstecker ziehen.
R
L
www.cambridge-audio.com
On Off
Loop OutputInput
Balanced Audio - Right Unbalanced
Audio - Right
Input
Loop Output
Input
Loop Output
Out
Control Bus
Trigger
IR Emitter
In
Out/Thru
In
In
Loop OutputInput
Balanced Audio - LeftUnbalanced
Audio - Left
azur 840W Class XDTM Power Amplifier
Power Rating: 230V AC ~ 50Hz
Max Power Consumption: 1600W
www.cambridge-audio.com
Designed in London, England
Power AC
Please ensure that loudspeaker terminals are fully tightened
Veuillez s'assurer que les bornes de l'enceinte sont entièrement serrées
Stereo
Mono
Bi-Amp
Bridged
Loudspeaker Terminals - Right
Impedance 4 - 8 ohms
Bridged
Bridged
only!
Please ensure that loudspeaker terminals are fully tightened
Veuillez s'assurer que les bornes de l'enceinte sont entièrement serrées
Loudspeaker Terminals - Left
Impedance 4 - 8 ohms
Bridged
only!
Manufactured in an ISO9001 approved facility
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference
2) This device must accept any interference, including interference that may cause undesired operation
N1863
46
1 = Ground
2 =
3 =
In Loop
1 = Ground
2 =
3 =
In Loop
Balanced Balanced
Unbalanced
Left
Input Type
Balanced
Unbalanced
Right
Input Type
IMPORTANT!
Only change modes
when unit is off.
Refer to Manual for
more information.
Use Left Input for
Bridged / Bi-Amp
operation.
Mono Mode
Class 2 WiringClass 2 Wiring
CAUTION
Risk of electric
shock.
Do not open.
AVIS
Risque de choc
electrique.
Ne pas ouvrir.
ACHTUNG
Vorm öffnen
des gerätes.
Netzstecker ziehen.
Nota: El modelo 840E incorpora una salida del accionador que también
se puede usar para controlar el estado de encendido o modo espera del
modelo 840W si lo desea. El procedimiento consiste en conectar
simplemente las dos unidades (con un cable mini-jack mono de 3,5 x
3,5 mm en este caso).
Se recomienda usar el bus de control cuando se esté utilizando el
modelo 840E junto con otro equipo de Cambridge Audio con entrada y
salida de bus de control.
También puede ser útil la entrada y salida del accionador si se desea
que el modelo 840W (también el 840E) esté controlado por otro equipo
que tenga salidas del accionador (instalación personalizada, sistemas
de hilo musical, etc.).
840W
840E
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cambridge Audio Azur 840W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cambridge Audio Azur 840W in the language / languages: Spanish as an attachment in your email.

The manual is 2,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cambridge Audio Azur 840W

Cambridge Audio Azur 840W User Manual - English - 12 pages

Cambridge Audio Azur 840W User Manual - German - 12 pages

Cambridge Audio Azur 840W User Manual - Dutch - 12 pages

Cambridge Audio Azur 840W User Manual - Danish - 12 pages

Cambridge Audio Azur 840W User Manual - French - 12 pages

Cambridge Audio Azur 840W User Manual - Italian - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info