651R/751Razur
15
ENGLISH
If it is desired to connect external power amplifiers, use Phono/RCA leads
connected to the 7.1 Preamp Outputs on the rear panel.
For 5.1/7.1 use set the 'Multi Ch.Out' setting in the 'Advanced Audio Setup'
OSD menu to 'Pre Out' rather than 'Normal'. This mutes all the internal power
amplifiers as they are not being used.
Alternatively the 651R/751R features an External 2-Channel mode. This
allows the 651R/751R to reproduce all the surround channels of suitable
source material (Centre, Surrounds and Sub) whilst the Left and Right Front
speakers are driven by an external power amplifier or other amplifier capable
of supporting fixed level inputs (e.g. Cambridge Audio’s own 8 series
amplifiers).
Set the 'Multi Ch.Out' to 'Ext 2ch' in the OSD to mute the 651R/751R’s own
front left and right amplifier outputs only:
Power amplifier/s
Surround back left
Surround left
Left
Right
Surround right
Surround back right
Centre
Phono cables
(2RCA-2RCA)
Front input connections
The front panel Video 3/MP3 input is for temporary connections to video
games consoles etc. Remove the cap to access the Video 3 inputs and
connect to a video game console or video camera’s outputs using stereo
phono cables (RCA-RCA) and a Composite video cable. Alternatively, use the
3.5mm mini-jack MP3 socket for the headphone/line outputs of portable
MP3 players.
FM aerial
Connect an aerial to the FM 75 ohm socket (a simple wire aerial is supplied
only for temporary use). Extend the lead and move the aerial around until you
get the best reception. For continued use, we strongly recommended using a
75ohm outdoor FM aerial.
AM loop aerial
Connect each end of the single length antenna to the antenna terminals.
Place the antenna as far from the main system as possible to prevent
unwanted noise and to obtain optimum reception. If the AM loop aerial
provided does not receive sufficient reception, it may be necessary to use an
outdoor AM aerial.
Aerial connections
FM aerial
FM external
aerial
AM external
aerial
AM loop
aerial
OR
OR
Ground
(optional)
7.1 preamp out
ic.
Video games console/
Video camera outputs
HDMI cable (751R only)
Composite video cable
S-Video cable
Toslink cable
Stereo phono cable (RCA-RCA)
OR
MP3
Player
When pressing Video 3/MP3, the 651R/751R automatically selects the MP3
socket if there is a device plugged into it.
Note: The Left front input is also used for the supplied auto setup
microphone. Refer to the ‘Auto setup’ section of this manual for more
information.
To use HDMI (751R only) first assign the HDMI input to the Video 3 source
via the On Screen Display (see later section). The front HDMI input is a HDMI
1.3c standard.