658987
9
Zoom out
Zoom in
Previous page
1/134
Next page
6
GB
D
F
NL
E
P
I
DK
N
S
FIN
TR
GR
PL
CZ
SK
H
SLO
RU
UA
HR
RO
ET
LT
LV
Use
Steam ironing
Set the iron temperature adjustment dial and the steam flow adjustment
dial (accordingto model) to the type of fabric to be ironed (see table below).
The thermostat light comes on.
To obtain steam, press on the steam control button on the iron handle -
fig.6.
The steam will stop when you release the button.
Start withthe fabrics to be ironed ata low temperature and finish with those
which need higher temperatures (••• or Max).
To prime the steam circuit, either before using the iron for the first time, or if
you have not used the steam function for a few minutes, press the steam
control button - fig.6. severaltimes in a row, holding the iron away from your
clothes.This will enable any cold water to be removed from the steam circuit.
For delicate fabrics, press the steam control button (on the handle of the
iron) intermittently to avoid possible water droplets appearing with the
steam.
If you are using starch, it should be sprayed onto the reverse side of the fa-
bric to be ironed.
Dry ironing
Do not press on the steam control button - fig.6.
Vertical steam ironing
Set the iron temperature dialand the steam flow adjustment
dial (according to model) to the max. position.
Hang the garment on a coat hanger and hold the fabric
slightly taut with one hand.
Press repeatedly on the steam control button - fig.6.(on the
iron handle) moving the iron from top to bottom - fig.7.
Filling the boiler during use
VERY IMPORTANT : Before opening your boiler, ensure that there is no more steam left inside by pres-
sing the steam control button - fig.6 located on the handle of the iron and keep it pressed down until
there is no more steam.
Stop the generator by pressing the on/off switch and disconnecting the plug.
Slowly unscrew the boiler cap.
Using a water jug, fill with maximum 1 litre of water.
Fill the boiler fig.4, taking care that the water does not spill over. If this occurs, remove theexcess water.
Replace the boiler cap, screwing on tightly, reconnect your generator to the mains, and switch it on.
Wait until the boiler heats up. After approximately 8 minutes or when the steam ready indicator light
comes on (according to model), the steam is ready.
Never uns-
crew the
boiler cap
while it’s
still stea-
ming.
T
he generator and the iron are
ready to iron when the steam
ready indicator light (according
t
o model) is lit and the iron
thermostat dial light has gone
out.
Mixed fibre fabrics : set the iro-
ning temperature to the setting
for the most delicate fabric.
Woollen garments : press repea-
tedly on the steam control but-
ton - fig.6 to obtain short bursts
of steam, without placing the
iron on the garment itself.
This will avoid making the fabric
shiny.
T
YPE OF FABRIC
S
ETTING THE TEMPERATURE
DIAL
S
ETTING THE STEAM DIAL
(according to model)
Linen, Cotton
•••
Wool, Silk, Viscose
••
Synthetic
(Polyester,Acetate,Acrylic, Polyamide)
As steam is very hot, never attempt to re-
move creases from a garment while it is
being worn, always hang garment on a coat
hanger. For fabrics other than linen or cotton,
hold the iron a few centimetres from the gar-
ment to avoid burning the fabric.
1800115362 GV52XX TEFAL:110x154 16/06/09 15:16 Page 6
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Calor GV5245 Easy Pressing at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Calor GV5245 Easy Pressing in the language / languages: All languages as an attachment in your email.

The manual is 3,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info