Manual Caliber PARK200 (page 7 of 78) (English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Spanish)

572017

Zoom out

Zoom in

1/78

USER MANUAL

OBJECTS MAYBE CAUSE FAILURE DETECTION

Smooth slope Smooth round object Objects absorbing wave,

e.g. Cotton

FAILURE HANDLING

A. If there were no sounds and light, please check and make sure that the wires

were connected correctly, the voltage is not lower than 9V, whether the display

was connected properly with the main unit.

B. If there were disordered display or continuous beep, please quit the reverse gear

and then enter the reverse gear again, if there were still the same problems, the

control unit is confirmed to be defective.

C. If the display gave long beep or showed 0.0m when the user test one of the

sensors. Please check whether there are other parts of the vehicle falling into

the detecting rage of the sensor being tested, whether the sensor was installed

too tightly, whether the sensor was installed close to some strong trembling

parts (such as exhaust pipe) of the car or whether there is some strong

interference close to the sensor.

D. If the display show some numbers but there are no obstuction in front of the

sensors, please check the direction of the sensors, maybe the system detects

some parts of the vehicle.

E. If the display showed in a disorder way when gunning the engine, it is the circuit

disturbing, please connect the system’s ground wires with the vehicle’s earth

wire.

F. If the system still could not work properly after the above mentioned handling,

the user can decide that the sensors don’t match with the control unit, the

whole system should be replaced.

CA PARK 200_manual 14-07-2006 14:01 Pagina 7

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Caliber PARK200 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 4,26 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Caliber PARK200 Manual

Product: