784919
7
Zoom out
Zoom in
Previous page
1/40
Next page
4
Installation
SITE PREPARATION
You probably have a spot picked out for your new spa, whether it’s indoors
or outdoors, on a patio or on a deck. Please make sure you check the
following:
Always put your spa on a structurally sound, level surface. A filled
spa can weigh a great deal. Make certain that the location you
choose can support the weight of your filled spa.
Don’t forget to level your spa before filling it. (See the Spa Leveling
Preparation.)
Locate your equipment compartment, which houses all of the
electrical components, in a place where water will drain away from
it. Allowing water into the equipment compartment can damage the
electronics, or may result in tripping your house’s circuit breaker.
Leave yourself easy access to the circuit breaker in the subpanel.
Leave access to the equipment compartment for periodic spa care
and maintenance.
WARNING: Damage to the spa’s equipment compartment
components or internal plumbing as a result of rodent
infestation is NOT covered under your warranty!
OUTDOOR AND PATIO INSTALLATION
No matter where you install your new spa, it’s important that you have a
solid foundation to support it. Structural damage to the spa, resulting from
incorrect installation, or placement on an inadequate foundation, is not
covered under the spa’s limited warranty.
If you install the spa outdoors, we recommend a reinforced concrete pad
at least 10 cm (four inches) thick. The reinforcing rod or mesh in the pad
should be attached to a bond wire.
DECK INSTALLATION
To be certain your deck can support your spa, you must know the deck’s
maximum load capacity. Consult a qualified building contractor or structural
engineer. To find the weight of your spa, its contents and occupants, refer
to the Spa Specification chart on back cover. This weight per square foot
must not exceed the structure’s rated capacity, or serious structural damage
could result.
INDOOR/BASEMENT INSTALLATION
Be aware of some special requirements if you place your spa indoors.
Water will accumulate around the spa, so flooring materials must provide
a good grip when wet. Proper drainage is essential to prevent a build-
up of water around the spa. When building a new room for the spa it is
recommended that a floor drain be installed. The humidity will naturally
increase with the spa indoors. Water may get into woodwork and produce
dry rot, mildew, or other problems. Check for airborne moisture’s effects
on exposed wood, paper, etc. in the room. To minimize these effects, it is
best to provide plenty of ventilation to the spa area. An architect can help to
determine if more ventilation must be installed.
CALDERA spas are equipped with a jet pump shroud to remove excessive
heat from the equipment compartment. Find this vent and be sure the vent
is not blocked by anything, including carpeting.
Your CALDERA dealer can help you with local information such as zoning
regulations and building codes.
WARNING: Please keep the area around your spa well ventilated
when it is installed indoors or in a confined area.
Inadequate ventilation around the spa could cause a build-up of a higher-
than-normal concentration of spa chemicals and/or bacterial fragments.
These dispersed spa chemicals and/or bacterial fragments can be
inhaled, and may result in breathing difficulties or lung damage in certain
people suffering from a compromised immune system or respiratory
infection. If you or other bathers are affected by this condition, please
seek medical attention as soon as possible.
In addition to the above, properly clean and maintain your spa as follows:
Follow all procedures in this owners manual and printed
instructions on all water care (chemical) products packaging.
Test the water regularly to ensure proper levels of sanitizers, pH,
and other water care requirements.
Drain, clean, and refill your spa with fresh water on a regular
schedule, and in accordance with this owners manual.
Clean the filter at least once per month.
Check to make sure you have proper circulation throughout your
spa water system.
Have spa users bathe before entering the spa water.
SPA LEVELING PREPARATION
Concrete sloped at 1.5 cm per 3 m (.5" per 10') is preferred so that rain
water and water spillover will run off and not puddle underneath the spa
(water under the spa for long periods of time may cause the wood to
deteriorate). Other options are brick, stepping stone, or blocks.
It is important to note that soft surfaces, even when stepping stones are
used to evenly distribute the weight of the spa, will have a tendency to
settle, thus resulting in an unleveled spa.
NOTE: Placing the spa on grass or dirt may increase the amount of debris
which is inadvertently brought into the spa water and may cause harm to
your equipment as well as the spa surface, which is not covered under
warranty.
Installation
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Caldera Vacanza - serie 2022 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Caldera Vacanza - serie 2022 in the language / languages: English as an attachment in your email.

The manual is 3.86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Caldera Vacanza - serie 2022

Caldera Vacanza - serie 2022 User Manual - German - 40 pages

Caldera Vacanza - serie 2022 User Manual - Dutch - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info