814932
24
Zoom out
Zoom in
Previous page
1/32
Next page
HUBLOT - FLOS - MAGRITTE
24
11.8 BLACKOUT WITH THE BOILER ON
In the event of a power cut (BLACKOUT) the boiler behaves as follows:
Blackout below 10”: it returns to its operation in progress;
In the event of a power cut that lasts over 10” with the boiler on or in the start-up stage, when the boiler is powered again it
goes back to the previous operating condition with the following procedure:
1) It performs a cooling phase to the maximum.
2) Performs a new ignition.
During stage 1 the panel displays ON BLACK OUT.
During stage 2 the panel displays Start-up.
If during stage 1 the boiler receives commands from the panel and thus carried out manually by the user, then the boiler stops
executing the blackout recovery status and proceeds to restart or shutdown as requested by the command.
11.9 ALARM ALERTS
Whenever an operating condition other than that designed for the regular operation of the boiler occurs, there is an alarm condition.
The control panel gives information on the reason of the alarm in progress.
PANEL ALERT TYPE OF PROBLEM SOLUTION
A01 The fire does not ignite.
Check whether the brazier is clean / level of pellets in the
hopper.
Check pellet level in the tank.
Check that the burning pot is correctly positioned in its
case and does not contain deposits or unburned material.
Check that the pellet cover and the fire door are correctly
closed.
Clogged flue
Damaged ignition resistance
A02 The fire goes off abnormally. Check the level of pellets in the hopper.
A03 Thermostat
alarms
The temperature of the pellets hopper or the
water temperature exceed the envisioned safety
threshold.
Wait for the cooling stage to end, cancel the alarm and
restart the boiler setting the fuel loading at minimum
(SETTINGS menu - Pellet Recipe).
Check that dust does not clog the aeration grid on the stove
back.
If the alarm persists, contact the service centre. Check if the
room fan works properly (if present).
A04 Smoke overheating. The set smoke threshold has been exceeded. Reduce pellets
loading (SETTINGS menu - Pellet Recipe).
A05 Pressure
switches alarm Flue gas pressure switch trip. (see SMOKE RPM
VARIATION User Manual)
Check for chimney obstructions/fire door opening, pellet
tank opening, gasket seals, side fire ducts cleaning, clogged
hose connection, excess flue length, unfavourable weather
conditions and clogged stove.
A08 Abnormal smoke fan operation. If the alarm persists, contact the service centre.
A09 Smoke probe faulty. If the alarm persists, contact the service centre.
SERVICE Routine maintenance alert (it does not block the
system).
When this flashing message appears upon start-up, it
means that the preset operating hours have elapsed before
maintenance. Contact the service centre.
11.10 ALARM RESET
To reset the alarm you must keep the 1 (ESC) button pressed for some time. The stove performs a check to determine whether the
warning cause is still present.
If this is the case, the warning will be shown again, otherwise the stove will switch to the OFF position.
If the warning is still present, contact a service centre.
12 ROUTINE MAINTENANCE
12.1 INTRODUCTION
For a long working life of the stove, have a periodic cleaning of the stove as described in the following paragrafs.
Fume outlet pipes (fume conduit + chimney flue + chimney pot) must always be cleaned, scrubbed and checked by an authorized
technician in compliance with local regulations, with the instructions of the manufacturer and those of your insurance company.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cadel HUBLOT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cadel HUBLOT in the language / languages: English as an attachment in your email.

The manual is 0.64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cadel HUBLOT

Cadel HUBLOT User Manual - German - 35 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info