541599

Cadac CARRI CHEF 8120 Manual

7
Zoom out
Zoom in
Previous page
1/13
Next page
6. Assembly Instructions
The hose and regulator are not supplied. For details contact your local stockist.Note:
Place the Burner Pan (D) (Fig.2) onto a clean surface with the Burner (N) facing down. Take a Leg (E1) (Fig.2 and 3a) and insert
the tapered end into one of the Leg Brackets making sure the slot in tapered end lines up with the key in the Leg Bracket. Slide the
Securing Ring (E2) onto the Leg Bracket, turn clockwise to engage thread, continue turning until tight. Do not over tighten.
Repeat this step for the other two legs.
Place the Carri Chef onto its legs.
Fit the Accessory Tray (F) by sequentially clipping all three fixing bosses into the Tray Clips (S). (Fig.3c)
To remove the legs, reverse the above procedure.
Fit the Valve Tailpiece (R) onto the Valve (O) (Fig.4) by screwing it on in an anti-
clockwise direction. Push an 8mm inside diameter Hose onto the Valve Tailpiece (R) until it is properly seated (See Fig.4). On the other
end, attach a suitable 30mbar low-pressure ( I 3B/P (30) and I 3+ (28-30/37) Butane configurations) or 37mBar low-pressure regulator
( I 3+ (28-30/37) Propane configuration), again making sure that the hose is well seated. The hose used must comply with BS 3212:1991 /
SABS 1156-2 or equivalent. In South Africa the regulator used must comply with SANS 1237.
I 3B/P (30) and I 3+ (28-30/37) Appliance categories:
Fig. 4
R
Important information for the installer.
The Tailpiece
is screwed on as
tight as possible
with your fingers.
Tighten 5-30 angle degrees
(½ - 1 face of a spanner/wrench)
with a suitable spanner/wrench.
When assembling the hose to the regulator the hose connections and the
Tailpiece should be tested for leakage with soapy water with normal
gas-pressure. In this way there must not be leakages
(seen as small soap bubbles).
Fig. 3a
Fig. 3b
Fig. 3c
E1
D
E1
E2
E1
S
F
O
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cadac CARRI CHEF 8120 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cadac CARRI CHEF 8120 in the language / languages: English as an attachment in your email.

The manual is 1,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cadac CARRI CHEF 8120

Cadac CARRI CHEF 8120 User Manual - German - 11 pages

Cadac CARRI CHEF 8120 Manual - Dutch - 16 pages

Cadac CARRI CHEF 8120 User Manual - Dutch - 11 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info