559501
8
Zoom out
Zoom in
Previous page
1/228
Next page
8
INSTALLING THE BATTERIES AND SD CARD
Before you begin learning how to use your NatureView Cam, you will first
need to install a set of batteries and insert an SD card. Although that may
only take you a minute, there are some important notes about both batteries
and SD cards you should be aware of, so please take the time to read the
following directions and cautions:
Loading Batteries
After opening the two latches on the right side of the
NatureView Cam, you will see that the NatureView
Cam has twelve battery slots, depending on your
model. For maximum battery life, you should install a
full set of batteries. The NatureView Cam may also
be operated by just four batteries installed in the first
slots only (starting on the left-see photos). Battery
life will be shorter with 4 batteries, but the camera will
operate normally. If the low battery indicator blinks,
remove and reinsert the 4 batteries to resume
operation, or install a full set. Whether you use 4 or
a full set, be sure to insert each battery with correct polarity (negative or “flat”
end against the long spring of each battery slot).
Bushnell recommends using a full set of new lithium AA (Energizer
®
brand)
or alkaline AA batteries. NiMh Rechargeable batteries are not recommended,
as the lower voltage they produce can cause operational issues. It is also
possible to use a lead-acid external battery cell with 6V output or suitable AC
adapter-see below for more details.
Using an External Power Source (optional, user provided)
Optionally, you can connect an external 6V DC power source to the “DC
In” jack at the bottom of the NatureView Cam. It is recommended to use a
power source with a current output greater than 1550mA. However, during
bright daytime operation when no flash is required, the NatureView Cam
can function with much less current ( >400mA). Please use a compatible
power source cable (not provided) to connect the external DC power source
with the power input jack of the NatureView Cam, making sure that the
polarity is correct. Note: The power connector is a 4.0x1.7mm coaxial DC
power plug with positive “tip” (inside pin) polarity (Radio Shack P/N 274-
1532 or equivalent).
WARNING: Be sure the camera’s power is switched OFF
before inserting or removing SD cards or batteries.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bushnell NatureView Cam HD MAX 119439 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bushnell NatureView Cam HD MAX 119439 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 3,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info