719101
45
Zoom out
Zoom in
Previous page
1/48
Next page
45
REGULAR MAINTENANCE
After grilling, you should prepare the grill for the next use. Let the grill burn freely at maximum heat
with the lid closed to burn up any residues on the grids and then brush them off.
Follow the procedure below to do this:
1. Remove all grilled food from the grill and set the grill to maximum heat with the lid closed. Let it
burn freely for 15-30 minutes until no more smoke comes out of the grill. For tough stains, turn the
grids so that the used side faces the bottom.
2. Close the gas cylinder valve (rotate to OFF) and subsequently turn the control knobs to the OFF
position.
3. Next, use a long-handled stainless steel brush to clean the grill. Make sure to wear grilling gloves or
potholders since the grill is still very hot.
4. When using cast iron grids pour some rapeseed or sunflower oil on a cloth and rub it on the grids to
prevent rust. Stainless steel grids need no further maintenance.
It is recommended that you clean the dirty spots on the edge of the cast iron grids separately every 23
times you use the grill. Here, you should first let the grill burn freely and then clean it using a wire brush.
To clean the dirty spots on the edges, remove the grids from the grill and scrub them carefully under
warm water (no detergent) using a wire sponge (pot sponge). Afterwards, use a cloth to dry them thoro-
ughly, apply some oil, and pace them back into the grill. Stainless steel grids can easily be cleaned with
detergent, sponge and warm water or in the dishwasher.
If the cast iron grids are rusty, scrub the rusty surfaces with steel wool until you have completely re-
moved all the rust. Next, wash the grids with water or warm soapy water, dry properly, and repeat the
burning-in process.
If possible, store the cast iron grids in a dry pace during winter.
General cleaning of the grill should be done every 34 months. You should let the grease residues burn,
empty the grease trap, and clean the grease tray and grids every time you use the grill.
REPLACING THE STAINLESS
-
STEEL BURNERS
If one or more burners are defective, repace the affected burner(s) as follows:
1. Remove the camping spring. Pull the burner back slightly and carefully lift out the corresponding
burner.
2. Clean or repace the defective burner(s). Put the burners back in the reverse order and secure the
burners with the camping spring.
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Burnhard Fred at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Burnhard Fred in the language / languages: English, German as an attachment in your email.

The manual is 15,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info