Manual Burley Rover 2008 (page 7 of 12) (English)

632548

Zoom out

Zoom in

1/12

B U R L E Y P E T T R A I L E R O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L

Removing Floor

For cleaning, floor may be removed by lifting at

front. Photo 10a Remove floor cover from base for cleaning

Reinsert floor rear under nuts in trailer rear and D-rings on

sides. In front corners, snap floor under front nuts. Photo 10b

Installing Safety Flag

Join pole sections together. On trailer's left side, insert flag

pole into flag receptacle on axle. DO NOT USE TRAILER

WITHOUT FLAG.

Operating Kickstand (Tail Wagon Only)

Use side knob to raise and lower kickstand.

Using Trailer as a Stroller (Tail Wagon Only)

Slide tow bar through both receptacles on left side. Line up

front tow bar hole with rear receptacle hole. Insert retaining

pin through both holes and lock retaining hoop securely. Place

stroller wheel in the “STROLL” (down) position and tighten knob.

To adjust wheel tracking (which allows stroller to roll straight):

1. Loosen bolt using 5 mm hex wrench. Figure 1

2. With 25 mm (1") wrench, adjust bushing until wheel is

aligned and trailer tracks straight.

3. Tighten bolt.

NOTE: Stroller and kickstand

available as accessories for the Rover.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Burley Rover 2008 in the language / languages: English as an attachment in your email.

The manual is 1 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Burley Rover 2008 Manual

Product: