632532
11
Zoom out
Zoom in
Previous page
1/20
Next page
OWNER’S INSTRUCTION & SAFETY MANUAL8
BURLEY.COM
Hooking up Your Trailer
1. Installing the hitch to your bike: Remove quick-release
or nut from the left side of bike’s rear wheel axle.
Install hitch between quick-release or nut and frame
(Figure 9). Tighten the quick-release or nut following
manufacturer’s recommendation. The
hitch can remain on the bike when trailer
is removed.
2. Hooking the tow bar to the hitch: Insert flex connector
in between the two holes on the hitch. Insert lock pin
and close retainer.
(Figure 10).
Accrochage de votre remorque
1. Installation de l’attelage sur votre vélo : Retirez le levier
de blocage rapide ou l’écrou du côté gauche de l’axe
de la roue arrière du vélo. Installez l’attelage entre le
levier de blocage rapide ou l’écrou et le cadre (Figure
9). Serrez le levier de blocage rapide ou l’écrou en
suivant les recommandations du fabricant. L’attelage
peut rester sur le vélo lorsque la remorque n’est pas
accrochée.
2. Accrochage de la barre de remorquage à l’attelage
: Insérez le raccord souple entre les deux trous sur
l’attelage. Insérez la goupille de sécurité et fermez le
dispositif de retenue. (Figure 10).
Conexión de su remolque
1. Colocación del enganche en la bicicleta: quite la
liberación rápida o la tuerca del lado izquierdo
del eje de la rueda trasera de la bicicleta. Instale
el enganche entre la liberación rápida o la tuerca
y el marco (figura 9). Apriete la liberación rápida
o la tuerca de acuerdo con la recomendación del
fabricante. El enganche puede permanecer en la
bicicleta cuando se quita el remolque.
2. Colocación de la barra de remolque en el enganche:
inserte el conectador flexible entre los dos orificios
del enganche. Inserte el pasador de bloqueo y cierre
el retén. (Figura 10).
Ankoppeln Ihres Anhängers
1. Montage der Anhängerkupplung an Ihrem Fahrrad:
Entfernen Sie den Schnellverschluss oder die Mutter
von der linken Seite der hinteren Radachse des
Fahrrads. Montieren Sie die Anhängerkupplung
zwischen dem Schnellverschluss oder der Mutter
und dem Rahmen (Abbildung 9). Ziehen Sie
den Schnellverschluss oder die Mutter gemäß
den Empfehlungen des Herstellers fest. Die
Anhängerkupplung kann am Fahrrad verbleiben, wenn
der Anhänger entfernt wurde.
2. Ankoppeln der Zugstange an der Anhängerkupplung:
Stecken Sie das flexible Verbindungsstück zwischen
die beiden Löcher der Anhängerkupplung. Stecken
Sie den Sicherungsstift hinein und schließen Sie die
Arretierung. (Abb. 10).
Figure 9
Figure 10
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Burley Nomad 2014-2015 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Burley Nomad 2014-2015 in the language / languages: English as an attachment in your email.

The manual is 2,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info