632540

Burley Flatbed 2015 Manual

10
Zoom out
Zoom in
Previous page
1/20
Next page
FLATBED 8
Hooking up Your Trailer
1. Installing the hitch to your bike: Remove
quick-release or nut from the left side of
bike’s rear wheel axle. Install hitch between
quick-release or nut and frame (Figure 8).
Tighten the quick-release or nut following
manufacturer’s recommendation. The
hitch can remain on the bike when trailer
is removed.
2. Hooking the tow bar to the hitch: Insert
flex connector in between the two holes on
the hitch. Insert lock pin and close retainer
(Figure 9).
Figure 8
Figure 9
Accrochage de votre remorque
1. Installation de l’attelage sur votre vélo :
Retirez le levier de blocage rapide ou l’écrou du
côté gauche de l’axe de la roue arrière du vélo.
Installez l’attelage entre le levier de blocage
rapide ou l’écrou et le cadre (Figure 8). Serrez
le levier de blocage rapide ou l’écrou en suivant
les recommandations du fabricant. L’attelage
peut rester sur le vélo lorsque la remorque
n’est pas accrochée.
2. Accrochage de la barre de remorquage à
l’attelage : Insérez le raccord souple entre
les deux trous sur l’attelage. Insérez la
goupille de sécurité et fermez le dispositif de
retenue (Figure 9).
Conexión de su remolque
1. Colocación del enganche en la bicicleta:
quite la liberación rápida o la tuerca del
lado izquierdo del eje de la rueda trasera
de la bicicleta. Instale el enganche entre
la liberación rápida o la tuerca y el marco
(figura 8). Apriete la liberación rápida o la
tuerca de acuerdo con la recomendación
del fabricante. El enganche puede
permanecer en la bicicleta cuando se quita
el remolque.
2. Colocación de la barra de remolque en el
enganche: inserte el conectador flexible
entre los dos orificios del enganche. Inserte
el pasador de bloqueo y cierre el retén
(figura 9).
Ankoppeln Ihres Anhängers
1. Montage der Anhängerkupplung an Ihrem
Fahrrad: Entfernen Sie den Schnellverschluss
oder die Mutter von der linken Seite der
hinteren Radachse des Fahrrads. Montieren
Sie die Anhängerkupplung zwischen dem
Schnellverschluss oder der Mutter und
dem Rahmen (Abbildung 8). Ziehen Sie den
Schnellverschluss oder die Mutter gemäß
den Empfehlungen des Herstellers fest. Die
Anhängerkupplung kann am Fahrrad verbleiben,
wenn der Anhänger entfernt wurde.
2. Ankoppeln der Zugstange an der
Anhängerkupplung: Stecken Sie das flexible
Verbindungsstück zwischen die beiden Löcher
der Anhängerkupplung. Stecken Sie den
Sicherungsstift hinein und schließen Sie die
Arretierung (Abbildung 9).
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Burley Flatbed 2015 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Burley Flatbed 2015 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 2,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info