623968
14
Zoom out
Zoom in
Previous page
1/17
Next page
25
For conversion table for °Fahrenheit and altitude’s temperature difference see the inner cover
18
18
Advice and recommendations on use
Clock setting
The Clock setting (24 hours) can be set when Vera does not heat or boil water.
Place Vera on the power base unit (5) and set the time very easily by following these simple steps:
a) Press the “mode” button (15) for 3 Seconds, until the “
” icon and hour numbers on the display start
ashing.
b) Press the setting button “” (16) to set the hour. One click corresponds to one hour and if the setting button
” (16) is keep pressed the number rises continuously until the required time is reached.
c) To set the minutes press the “mode” button (15) one time again and minute numbers start ashing.
d) Press the setting button “” to set the minutes. One click corresponds to one minute and if the setting
button “” (16) is kept pressed the number rises continuously until the required time is reached.
e) After setting the minute, press “mode” button (15) for 3 Seconds to nish the setting.
f) To turn the display on clock(10B) or temperature(10A) press one time the setting button “” (16) This
operation can be done when the Vera kettle is not heating or boiling.
Special instruction
A) Safety cut-off
Vera is protected against damage resulting from use with an insufcient volume of water. In case user press
the button on/off (14) and on the kettle display the blue light “ml minimum” blink, the kettle will not operate
and eventually ll the kettle with water till, on the display, the blue light of the level “ml minimum” stop to
blink and the blue light of the level “800ml” is on. Only in this way the kettle can start to operate.
In case user press the button on/off (14) and the kettle is empty or nearly empty and for wrong water level
signal the kettle start to heat, a safety cut-off will automatically disconnect the power supply if the heating
element over heats. Should the kettle ever boil dry during operation, you must leave it to cool for 10 minutes
before relling it with cold water. Pull up the kettle from the power base, after cooling down. The safety
cut-off will reset automatically once the kettle has cooled.
B) Before using Vera kettle
Clean the inside of Vera kettle before using it for the rst time by lling it completely (to the MAX level)
with water, boiling the water following the BOILING FUNCTION and then discarding the water. Repeat this
operation two times and any time that the kettle has not been used for long time.
C) Display reset If the display is not showing correctly the functions need to
be reset. This is for safety to refresh all MCU memory inside.
Place the Vera kettle on the power base unit (5). Plug it in.
Press the reset button (18) by using a part of a metal clip
or by toothpick for 5 seconds . The display will be back to
the original settings and all pre set settings (clock, timer
and temperature) will be lost.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bugatti Vera at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bugatti Vera in the language / languages: English as an attachment in your email.

The manual is 3,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bugatti Vera

Bugatti Vera User Manual - German - 17 pages

Bugatti Vera User Manual - French - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info