678414
7
Zoom out
Zoom in
Previous page
1/20
Next page
Igniting the hokker
1. Place the pan carrier .
2. Turn the knob to the “normal" position. keep the knob pressed and press the ignition button a few times
until the burner is burning completely. Keep the knob pressed in for approximately a further 10
seconds. The burner will continue to burn.
Turning off the gas griddle:
3. Turn the knob completely to the right. The burner will go out.
Note! After turning off the burners, wait approximately 10 minutes before reigniting the burners.
After turning off the burners, always turn off the main tap on the gas cylinder!
Problems: possible cause
gas ring will not light: - ignition defective
- thermocouple defective
- igniter dirty
- pressure regulator defective
- gas bottle empty
- gas hose kinked
- injector blocked
gas ring does not light fully: - gas bottle (almost) empty
- gas hose kinked
- gas tap on gas bottle not fully open
- main injector blocked
- gas tap defective
comment:
It is to be recommended to replace the gas hose after 3 or 4 years ( see date shown on hose ).
The gas hose becomes porous after a time.
Consult the local regulations, these may differ.
Always store gas bottles upright, even when empty.
Guarantee
Any defect affecting the functionality of the appliance which becomes apparent within one year of its purchase
will be corrected by free repair or replacement provided that it has been used and maintained in accordance
with the instructions and has not
been abused or misused in any way. Your statutory rights are not affected. If it’s
under guarantee, state where and when it was bought, and include proof of purchase (e.g. till receipt).
In line with our policy of continuous product development we reserve the right to change product, packaging
and documentation specifications without notice.
Discard
At the end of the life of the appliance, please dispose of the appliance in accordance with the rules and
guidelines applicable at that time.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Buffalo L492 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Buffalo L492 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info