678367
25
Zoom out
Zoom in
Previous page
1/93
Next page
SNMP Trap
Configure SNMP traps.
Note: To use SNMP traps, register the host to the host table on the [Basic] - [SNMP] - [SNMP Host Table] page and
enable “trap” for that community.
Compatible traps:
0 coldStart
1 warmStart
2 LinkDown (Link Up/Down)
3 LinkUp (Link Up/Down)
4 authenticationFailure (Authentication Trap)
6 topoligyChange (STP)
7 Loop detection (Loop Detection)
Private MIB OID: 1.3.6.1.4.1.5227.28.1.1.1
8 Trunk (Trunk)
Private MIB OID: 1.3.6.1.4.1.5227.28.1.1.2 (the value differs depending on the trunk’s link status as below)
1.3.6.1.4.1.5227.28.1.2.1 (trunk key 1-8)
1.3.6.1.4.1.5227.28.1.2.2 (link up: 1, link down: 2)
All traps can be enabled/disabled except coldStart and “warmStart”.
SNMP Trap Enable or disable all of the following traps.
Authentication Trap
If enabled, the trap will be sent when SNMP is requested from an unallowed IP
address.
Link Up/Down If enabled, the trap will be sent when link up/down of the port is detected.
STP
If enabled, the trap will be sent when STP/RSTP/MSTP topology change is
occurred.
Loop Detection If enabled, the trap will be sent when the loop is detected.
Trunk If enabled, the trap will be sent when the trunk is configured or unconfigured.
24
Chapter 2 Settings
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Buffalo BS-GS2016 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Buffalo BS-GS2016 in the language / languages: English as an attachment in your email.

The manual is 3,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info