784864
8
Zoom out
Zoom in
Previous page
1/40
Next page
SAFETY INSTRUCTIONS
IMPORTANT: Failure to wait 30 seconds
before resetting the GFCI may cause the
hot tubs Power Indicator (on the control
panel) to blink. If this occurs, repeat the
GFCI test procedure.
DANGER - RISK
OF ELECTRIC SHOCK
A wire connector is provided on this unit
to connect a minimum 8 AWG
(8.4 mm2) solid copper conductor be-
tween this unit and any metal equipment,
metal enclosures of electrical equipment,
metal water pipe, or conduit within 5 feet
(1.5 m) of the unit.
• Install at least 5 feet (1.5 m) from all
metal surfaces. As an alternative, a hot
tub may be installed within 5 feet of
metal surfaces if each metal surface is
permanently connected by a minimum 8
AWG (8.4 mm2) solid copper conductor
to the wire connector on the terminal
box that is provided for this purpose.
Do not permit any electric appliance,
such as a light, telephone, radio, or tele-
vision, within 5 feet (1.5 m) of a hot tub.
Failure to maintain a safe distance may
result in death, or serious personal injury
due to electrocution, if the appliance
should fall into the hot tub.
• Install your hot tub in such a way that
drainage is away from the electrical
compartment and from all electrical
components.
• CAUTION — Risk of Electric Shock.
Do not leave compartment door open
• CAUTION — Risk of Electric Shock.
Replace components only with identical
components
• Do not service this product yourself as
opening or removing covers may expose
you to dangerous voltage or other risk
of injury. Refer all servicing to qualified
service personnel.
DO:
• Be sure your hot tub is connected to the
power supply correctly - use a licensed
electrical contractor.
• Disconnect the hot tub from the power
supply before draining the hot tub or
servicing the electrical components.
• Test the Ground Fault Circuit Interrupt-
er(s) before each use.
• Do not use the hot tub with the equip-
ment compartment door removed.
• Do not place electrical appliances within
5 feet (1.5m) of the hot tub.
• Do not use an extension cord to connect
the hot tub to its power source. The
cord may not be properly grounded and
the connection is a shock hazard. An
extension cord may cause a voltage drop,
which will cause overheating of the jet
pump motor and motor damage.
• Do not attempt to open the electrical
control box. There are no user service-
able parts inside.
RISKS TO AVOID
DANGER - RISK OF INJURY
To reduce the risk of injury to persons,
DO NOT remove suction fittings (filter
standpipes) located in the filter compart-
ment.
There is a danger of slipping and falling.
Remember that wet surfaces can be very
slippery. Take care when entering or
exiting the hot tub.
Never operate hot tub if the suction
fittings are broken or missing.
People with infectious diseases should
not use the hot tub.
Keep any loose articles of clothing, long
hair, or hanging jewelry away from ro-
tating jets or other moving components.
8
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bueno Spa Atlanta at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bueno Spa Atlanta in the language / languages: English as an attachment in your email.

The manual is 6.43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info