636472

Buderus Logano G315 Manual

25
Zoom out
Zoom in
Previous page
1/56
Next page
9
Installing a control panel
Logano G315 – 6 720 817 939 (2016/04) 25
9 Installing a control panel
9.1 Installing the Logamatic control panel
Fig. 46 shows the control panel and the front top cover from behind.
▶ Undo both screws in the terminal cover (Fig. 46, [1]). Lift the
terminal cover up and off.
▶ Put the control panel in place. Fit the control panel at the front by
inserting the alignment tabs (Fig. 46, [4]) into the oval holes in the
front top boiler cover (Fig. 46, [5]). Pull the control panel forwards
and then tip backwards. The flexible hooks (Fig. 46, [2]) must
engage with the rectangular cutouts in the rear of the front boiler
cover (Fig. 46, [3]).
▶ Screw the base of the control panel on the left and right of the cable
duct (Fig. 46, [6]) on the front boiler cover using two self-tapping
screws (Fig. 46, [7]).
Fig. 46 Installing the control panel
9.2 Installing the temperature sensor assembly
▶ If necessary, make knock-outs (Fig. 47, [1]) in the rear panel of the
cable entry (Logamatic 33..) or remove the rear panel section
(Logamatic 43..) (Fig. 47, [2]).
▶ Route the capillary tubes through the cable entry and unroll to the
required length.
Fig. 47 Preparing the cable entry
The sensor well has already been sealed in the flow connection socket
( Chapter 7.5, page 17).
The temperature sensor set connected to the control panel (consisting
of three temperature sensors and one sensor blind piece Fig. 48,
[1]) is installed in the sensor well R¾ ".
▶ Route capillary pipe sensor to the measuring port of the boiler and
then guide the sensor into the sensor well (Fig. 48, [2]) and secure
with the retaining clip (Fig. 48, [3]).
Fig. 48 Fitting the sensor set
▶ Screw cable entry (Fig. 49, [1 and 2]) to the left and right of the rear
boiler panel.
A permanent connection must be made in accordance with EN 50165 or
the relevant national installation standard.
Observe the following when connecting the control
panel:
▶ Lay out cables and capillaries carefully.
▶ Do not bend the capillaries during installation.
▶ Never carry out any electrical work on the heating
system unless you are licensed for this type of work.
If you are not suitably qualified, arrange for a
qualified electrician to make the electrical
connections.
▶ Observe the local regulations!
1
2
45637
6 720 615 362-18.2O
6 720 642 623-58.1o
1
2
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Buderus Logano G315 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Buderus Logano G315 in the language / languages: English as an attachment in your email.

The manual is 3,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Buderus Logano G315

Buderus Logano G315 User Manual - English - 8 pages

Buderus Logano G315 Installation Guide - French - 56 pages

Buderus Logano G315 User Manual - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info