636472

Buderus Logano G315 Manual

20
Zoom out
Zoom in
Previous page
1/56
Next page
7
Boiler block assembly
Logano G315 – 6 720 817 939 (2016/04)20
7.8 Installing fittings and burner door
Next step in the assembly process is to install the burner door and draft
diverter. The pre-assembled boiler comes with these components
already installed.
7.8.1 Positioning the draft diverter
KM ropes (Fig. 28, [1]) are used to seal the connections between the
boiler and the draft diverter (Fig. 28, [2]).
▶ Coat the packing grooves with adhesive (primer).
▶ Push the KM ropes firmly into the groove. Insert the sealant rope in
such a way that the joint is in the side part of the groove (Fig. 28,
[3]).
▶ Place the draft diverter onto the two threaded studs on the rear
section (Fig. 28, [4 and 5]) and secure using washers and nuts.
Fig. 28 Fitting the draft diverter
7.8.2 Screwing cleanout cover onto rear section
Fig. 29 shows the fully equipped rear section with the cleanout covers
on the draft diverter (Fig. 29, 1 and 2]) and the cleanout covers on the
rear section (Fig. 29, [3 and 4]).
All cleanout covers are factory-fitted.
Fig. 29 Rear section with fittings installed
7.8.3 Inserting the flue gas baffle plates
▶ Take flue gas baffles from the crate and insert into the flue gas
passages as indicated by their inscription ( Fig. 30 and
Tab. 10).
Fig. 30 Flue gas baffle plates
7.8.4 Fitting burner door panel
In the factory, the burner door is mounted with the hinges on the right
hand side (Fig. 31, [4 and 6]). For left-hand closing, remove the hinges
accordingly on the left-hand side of the burner door.
▶ Screw the hinge pins (Fig. 31. [1 and 3]) to the front boiler section
with 2 M 12 x 50 machine screws in each case. This is shown in
Fig. 31 for the right-hand closing version. For left-hand closing,
secure hinge pins accordingly on the left-hand side.
▶ Affix Ø 18 mm diameter GP cord in the front section using adhesive.
The sealant rope joint should be located at the side (Fig. 31, [2]).
▶ Hook the burner door with the hinge lobes into the hinge pins.
In pre-assembled boilers, the flue gas baffles are already
fitted
▶ Remove the cardboard transport protectors from the
pre-assembled boiler.
Number of
boiler
sections
Number of
flue gas
baffle plates
Length of flue gas
baffle plate in
inches (mm)
Installation directions
on the flue gas baffle
plate ( Fig. 30)
5 4 14-11/64 (360) top right
top left
bottom right
bottom left
6 – 7 4 17-21/64 (440)
8 4 14-11/64 (360)
9 4 7-7/8 (200)
Table 10
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Buderus Logano G315 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Buderus Logano G315 in the language / languages: English as an attachment in your email.

The manual is 3,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Buderus Logano G315

Buderus Logano G315 User Manual - English - 8 pages

Buderus Logano G315 Installation Guide - French - 56 pages

Buderus Logano G315 User Manual - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info