560474
34
Zoom out
Zoom in
Previous page
1/100
Next page
34
We reserve the right to make any changes due to technical modifications!
Installation and Servicing Instructions Logamax plus GB142-24/30/45/60 • Version 12/2004
Buderus Hydronic Systems • http://www.buderus.net
Start-up procedure9
z Disconnect the plug and socket connection of the
monitoring cable and connect the measuring device
in series (fig. 33). Select the µA direct current range
on the measuring device. The measuring device
must have a resolution of at least 1 µA.
z Switch on the heating system using the main switch.
z Press the "Chimney Sweep"
button and hold it (for
approx. two seconds), until the display shows the
decimal point.
z Press and hold the "Chimney Sweep"
and
"Service"
buttons, until the display shows "/[["
(e. g. /).
z Set the appliance to partial load "/" by pressing the
"Chimney Sweep"
button (higher values) or the
"Reset"
button (lower values).
z Measure the ionization current. When the appliance
is in partial load mode the ionization current must be
>5µADC.
z Enter the value measured in the start-up report.
z Repeatedly press the "Service"
button, until the
temperature indication is displayed.
z Press the "Chimney Sweep"
button to end the
measurement procedure.
z Switch off the heating system using the main switch.
z Remove the measuring device and restore the plug
and socket connection.
z Switch on the heating system again using the main
switch.
Fig. 33 Measuring the ionization current
+
= higher values = lower values
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Buderus Logamax plus GB142-45 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Buderus Logamax plus GB142-45 in the language / languages: English as an attachment in your email.

The manual is 4,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Buderus Logamax plus GB142-45

Buderus Logamax plus GB142-45 User Manual - German - 16 pages

Buderus Logamax plus GB142-45 User Manual - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info