650241

BT Quartet 1000 additional handset Manual

2
Zoom out
Zoom in
Previous page
1/2
Next page
Q
u
i
c
k
d
i
a
l
9
1
2
3
4
56
78
0
▲
▼
M1 M2
A
B
C
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
D
E
F
Redial
Secrecy
R
1471
Channel
I
n
u
s
e
B
a
t
t
e
r
y
L
o
w
In Use/Battery
Low light
Indicates when the
handset rings, is in
use or, if the hand-
set is on standby, to
indicate the battery
needs recharging.
M1/M2 buttons
Allows you to store
and dial one touch
numbers.
Talk button
Press to make or
receive a call.
Quickdial button
Allows you to store
and dial up to 10
numbers in the
memory.
Redial button
Redials the last
number called, or
press to enter a
pause in a stored
number.
Secrecy
Press to mute the
call so your caller
cannot hear you.
Charging contacts
Aerial
Can be extended.
Volume control
buttons
Adjusts the handset
ringer and earpiece
speech volume.
Channel button
Selects an alterna-
tive radio frequency
if
interference occurs
during a call.
Keypad
Recall button
For use with a
switchboard/PBX
and BT Select
Services.
1471 button
Lets you hear the
telephone number
of the last person
who called.
Setting up
Follow these steps to get your Quartet 1000 addi-
tional handset ready for use.
Like all cordless phones, your Quartet 1000
additional handset will need charging for 24
hours before use.
1 Plug the power cable into the charging unit
Plug the power cable into the socket located on
the bottom of the charging unit, then feed the
cable through the channel.
Quartet 1000 – Edition 3 – 5/9/00 approved
If you experience any problems then please call
the Quartet Helpline on
0845 769 7146
1
2 Connect the power supply unit into a
convenient mains socket
3 Place the handset on the charging unit
Make sure the red CHARGING light at the front
of the charging unit comes on.
4 Leave the handset to charge for 24 hours
When fully charged and in good condition, the
handset will provide up to 7 hours talktime or
72 hours standby.
If the handset battery is running low, the IN
USE/BATTERY LOW light will flash every
10–15 seconds.
If you are making a call and the handset
battery is running low you will hear a warning
tone every 10–15 seconds.
Registering your handset
You must register your Quartet additional hand-
set before it can be used with your Quartet base
unit. Make sure that each additional handset is
registered with a different number (2, 3 or 4) so
it can be identified from other additional hand-
sets, see page 3.
The Quartet 1500 does not feature a PAGE
button. When registering an additional handset
to a base unit please use the base unit
INTERCOM button.
To register an additional handset
• Place the handset you wish to register on the
base unit and then remove it.
• Press
and hold the base unit PAGE button for
5 seconds until both the POWER/IN USE light
on the base unit and the IN USE/BATTERY
LOW light on the handset begin to flash.
•
Release the PAGE button and press the TALK
button on the handset.
• Your additional handset is registered
automatically and you will hear a long
confirmation beep and the IN USE light will
stop flashing.
Page
Quartet 1000 – Edition 3 – 5/9/00 approved
2
To set the handset number
Each additional handset must be assigned an
identity number (2, 3 or 4). Your Quartet 1100 or
1500 handset is already registered as HANDSET 1.
A Quartet additional handset is pre-set as HAND-
SET 2. However, further additional handsets can
be numbered as they are added.
• Press the
QUICKDIAL button.
• Press the
SECRECY button.
• Enter the handset number between (2 and 4).
• Press the
QUICKDIAL button. You will hear a
beep confirming that the new number has been
stored.
Check that your Quartet 1000 handset is
registered correctly by pressing the
TALK button
and listening for a dial tone. If you do not hear
a dial tone your Quartet 1000 handset is either
out of range of the base unit or it has not been
registered properly, or the base unit line cord is
not plugged in.
Make a note of the handset number by writing
it on the quickdial label on the additional
handset’s charger.
Q
u
i
c
k
d
i
a
l
Q
u
i
c
k
d
i
a
l
Secrecy
Quartet 1000 – Edition 3 – 5/9/00 approved
To erase a registration code
• Press the QUICKDIAL button
• Press the
CHANNEL button.
• Press the
✱
button 4 times.
• Press the
QUICKDIAL button. You will hear a
confirmation tone.
Your old registration code is now erased and
you can re-register your Quartet 1000 handset
following the procedure above.
Q
u
i
c
k
d
i
a
l
Q
u
i
c
k
d
i
a
l
To re-register an additional handset
Before re-registering, the old registration code
must first be erased. If necessary you can
re-register your Quartet 1000 handset by simply
following the above procedures.
3
The handset range is up to 250 metres from the
base unit in ideal conditions. If you start to go
out of range while using the phone, you will
hear warning beeps. Move closer to the base
unit. If you do not move back into range your
call may be disconnected.
Your Quartet 1000 additional handset uses a
compact aerial which can be pulled out to
obtain the best signal and reception available.
Page button – Quartet 1100
The Quartet 1100 base unit features a PAGE but-
ton. When pressed, the base unit and all the
handsets registered to that base unit will ring
and the IN USE/BATTERY LOW light on the
handset will flash. The
PAGE button feature does
not enable conversation between the base unit
and handset.
Quartet 1000 – Edition 3 – 5/9/00 approved
To end a call
• Press the TALK button.
Or
• Replace the handset on the base unit.
Using your Quartet
1000 Additional
Handset
Your Quartet 1000 can be used with the Quartet
1100 and Quartet 1500. Please refer to your main
Quartet User Guide for a complete list of product
features and operating instructions.
To make an external call
Press the buttons in the order shown:
• Lift the handset off the base unit.
• Press the
TALK button. The POWER/IN USE
light on the base unit begins to flash and the
IN USE light on the handset comes on.
• Listen for the dialling tone.
• Dial the number you want.
4
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BT Quartet 1000 additional handset at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BT Quartet 1000 additional handset in the language / languages: English as an attachment in your email.

The manual is 0,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info